AN 981: Using Generic QSPI Flash on SDM Devices

Download PDF
ID 778053
Date 7/02/2024
Public
Document Table of Contents
Document Table of Contents x
1. Introduction 2. Overview 3. Requirements 4. Implementation Flow 5. Debugging QSPI Flash Device using QSPI Debugger 6. Document Revision History for AN 981: Using Generic QSPI Flash on SDM Devices
3. Requirements x
3.1. QPI Mode (4-4-4 protocol) 3.2. Sector Erase Size 3.3. Maximum QSPI Clock 3.4. QSPI Flash Device Reset Pin 3.5. QSPI Page Program Opcode 3.6. SFDP Parameters
4. Implementation Flow x
4.1. Generating Programming Files using Programming File Generator 4.2. Programming .jic files into QSPI Flash Device 4.3. Hard Processor System (HPS) Support
1. Introduction
2. Overview
3. Requirements
4. Implementation Flow
5. Debugging QSPI Flash Device using QSPI Debugger
6. Document Revision History for AN 981: Using Generic QSPI Flash on SDM Devices

4.2. Programming .jic files into QSPI Flash Device

To program the .jic file into the QSPI flash device through the JTAG interface, perform the following steps:
  1. In the Programmer window, click Hardware Setup and select the desired download cable.
  2. In the Mode list, select JTAG.
  3. Select the device to be programmed and click Change File.
  4. Select the .jic file to be programmed to the selected device.
  5. Click Start to start programming.
Level Two Title