AN 981: Using Generic QSPI Flash on SDM Devices

Download PDF
ID 778053
Date 7/02/2024
Public
Document Table of Contents
Document Table of Contents x
1. Introduction 2. Overview 3. Requirements 4. Implementation Flow 5. Debugging QSPI Flash Device using QSPI Debugger 6. Document Revision History for AN 981: Using Generic QSPI Flash on SDM Devices
3. Requirements x
3.1. QPI Mode (4-4-4 protocol) 3.2. Sector Erase Size 3.3. Maximum QSPI Clock 3.4. QSPI Flash Device Reset Pin 3.5. QSPI Page Program Opcode 3.6. SFDP Parameters
4. Implementation Flow x
4.1. Generating Programming Files using Programming File Generator 4.2. Programming .jic files into QSPI Flash Device 4.3. Hard Processor System (HPS) Support
1. Introduction
2. Overview
3. Requirements
4. Implementation Flow
5. Debugging QSPI Flash Device using QSPI Debugger
6. Document Revision History for AN 981: Using Generic QSPI Flash on SDM Devices

4. Implementation Flow

You can proceed to use the QSPI flash device for FPGA configuration after successfully verifying it meets requirements. This section describes the steps required to generate programming files and program the verified QSPI flash using the Quartus Programmer.


Section Content
Generating Programming Files using Programming File Generator
Programming .jic files into QSPI Flash Device
Hard Processor System (HPS) Support

Level Two Title