Ethernet Subsystem Intel® FPGA IP User Guide

Download PDF
ID 773413
Date 9/16/2024
Public

A newer version of this document is available. Customers should click here to go to the newest version.

Document Table of Contents
Document Table of Contents x
1. Introduction 2. Feature Description 3. Ethernet Subsystem Parameters 4. Subsystem IP Blocks 5. Interfaces and Signals 6. Recommended Clock Connections 7. Register Descriptions 8. Ethernet SS IP Example Design 9. Document Revision History for the Ethernet Subsystem Intel FPGA IP User Guide
1. Introduction x
1.1. Supported Features 1.2. Device Family Support 1.3. Release Information 1.4. Resource Utilization 1.5. Getting Started
2. Feature Description x
2.1. Ethernet Subsystem Intel FPGA IP Overview 2.2. Supported Features
3. Ethernet Subsystem Parameters x
3.1. Parameter Editor Parameters 3.2. E-Tile Port Enablement Guidelines and Restrictions 3.3. F-Tile Ethernet Port to PMA Channel Mapping 3.4. Analog Parameter Options
4. Subsystem IP Blocks x
4.1. AXI Stream Bridge 4.2. CSR Address Decoder 4.3. Subsystem Abstraction Layer (SAL) 4.4. Dynamic Reconfiguration Extension Subsystem 4.5. IEEE 1588v2 PTP 4.6. Auto-Negotation and Link Training 4.7. Priority Flow Control
4.3. Subsystem Abstraction Layer (SAL) x
4.3.1. Subsystem Abstraction Layer (SAL) Commands
4.3.1. Subsystem Abstraction Layer (SAL) Commands x
4.3.1.1. NOP(0x0) 4.3.1.2. get_hssi_profile for E-Tile 4.3.1.3. get_hssi_profile for F-Tile 4.3.1.4. set_hssi_profile for E-Tile 4.3.1.5. set_hssi_profile for F-Tile 4.3.1.6. read_MAC_statistic 4.3.1.7. get_mtu 4.3.1.8. set_csr for E-Tile 4.3.1.9. set_csr for F-Tile 4.3.1.10. get_csr for E-Tile 4.3.1.11. get_csr for F-Tile 4.3.1.12. enable_loopback for E-Tile 4.3.1.13. enable_loopback for F-Tile 4.3.1.14. disable_loopback for E-Tile 4.3.1.15. disable_loopback for F-Tile 4.3.1.16. Reset MAC Statistics 4.3.1.17. set_mtu for F-Tile 4.3.1.18. Ncsi_get_link_status 4.3.1.19. Reserved 4.3.1.20. firmware_version (0xFF)
4.5. IEEE 1588v2 PTP x
4.5.1. TX PTP Classifier
5. Interfaces and Signals x
5.1. AXI4 Interfaces 5.2. Serial Interface 5.3. Clocks 5.4. Resets
5.1. AXI4 Interfaces x
5.1.1. AXI-Lite CSR 5.1.2. AXI-ST Client Interface 5.1.3. AXI-ST PHY Direct 5.1.4. AXI-ST PTP 5.1.5. Flow Control
6. Recommended Clock Connections x
6.1. Driving Multiple Ports with the Same Clock 6.2. Clock Connections for MAC Asynchronous Client FIFO 6.3. F-Tile Clock Connections for PTP Synchronous and Asynchronous cases 6.4. Clock Connections for SyncE Operation on E-Tile 6.5. Clock Connections for SyncE Operation on F-Tile 6.6. F-Tile PMA and FEC Direct PHY IP Clock Output
7. Register Descriptions x
7.1. Subsystem Registers 7.2. Port Registers 7.3. F-Tile Address Maps 7.4. F-Tile ANLT Port Register Map 7.5. F-Tile PTP Tile Adapter Register Map 7.6. F-Tile DR Controller Register Map
7.1. Subsystem Registers x
7.1.1. Device Feature Header Lo 7.1.2. Device Feature Header Hi 7.1.3. Feature GUID_L 7.1.4. Feature GUID_H 7.1.5. Feature CSR ADDR 7.1.6. Feature CSR Size Group 7.1.7. Version 7.1.8. Feature List 7.1.9. Interface Attribute Port X Parameters 7.1.10. HSSI Command/Status 7.1.11. HSSI Control/Address 7.1.12. HSSI Read Data 7.1.13. HSSI Write Data 7.1.14. HSSI Ethernet Port X Status 7.1.15. Priority Flow Control 7.1.16. Priority Flow Control TX Queue Statistics 7.1.17. Priority Flow Control RX Queue Statistics 7.1.18. Priority Flow Control TX Queue Threshold 7.1.19. Priority Flow Control RX Queue Threshold 7.1.20. F-Tile DR Controller Status
7.2. Port Registers x
7.2.1. PTP Packet Classifier Registers
7.2.1. PTP Packet Classifier Registers x
7.2.1.1. Recognized and Unrecognized Packet Counters 7.2.1.2. Parse Graph Specific Packet Counters
8. Ethernet SS IP Example Design x
8.1. Steps to Generate the Example Design 8.2. Supported Simulators 8.3. Running the Simulation Tests 8.4. Running the Hardware Tests
8.3. Running the Simulation Tests x
8.3.1. Steps to Simulate the Design Example
8.4. Running the Hardware Tests x
8.4.1. Supported Boards 8.4.2. Steps to Compile the Design Example for Hardware 8.4.3. Steps to Run the Design Example on Hardware
8.4.2. Steps to Compile the Design Example for Hardware x
8.4.2.1. Steps to generate Routing Delay for PTP Enabled Designs
1. Introduction
2. Feature Description
3. Ethernet Subsystem Parameters
4. Subsystem IP Blocks
5. Interfaces and Signals
6. Recommended Clock Connections
7. Register Descriptions
8. Ethernet SS IP Example Design
9. Document Revision History for the Ethernet Subsystem Intel FPGA IP User Guide

5.4. Resets

Table 47.  Reset Signals
Signal Name Direction Type Description
subsystem_cold_rst_n In Reset

Asynchronous, active-low hard global reset.

Resets the TX MAC, RX MAC, TX PCS, RX PCS, transceivers (transceiver reconfiguration registers and interface), and Ethernet reconfiguration registers.

This reset leads to the de-assertion of the o_tx_lanes_stableand o_rx_pcs_ready output signals.
i_p<n>_tx_rst_n In Reset

Asynchronous, active-low hard reset.

Resets the TX interface, including the TX PCS and TX MAC. This reset leads to the de-assertion of the o_tx_lanes_stable output signal.

i_p<n>_rx_rst_n In Reset

Asynchronous, active-low hard reset.

Resets the RX interface, including the RX PCS and RX MAC. This reset leads to the de-assertion of the o_rx_pcs_ready output signal.

o_p<n>_tx_rst_ack_n Out Reset Acknowledge

Activelow acknowledge signal for i_tx_rst_n.

The user should not de-assert i_tx_rst_n until o_tx_rst_ack_n is asserted.
o_p<n>_rx_rst_ack_n Out Reset Acknowledge

Activelow acknowledge signal for i_rx_rst_n.

The user should not de-assert i_rx_rst_n until o_rx_rst_ack_n is asserted.
subsystem_cold_rst_ack_n Out Reset Acknowledge

Activelow acknowledge signal for subsystem_cold_rst_n.

The user should not de-assert subsystem_cold_rst_n until subsystem_cold_rst_ack_nis asserted.
Table 48.  Reset Signals- Block Level
Reset Signal Ethernet Subsystem IP Block
subsystem_cold_rst_n
  • Tile Adaptor TX Logix
  • Tile Adaptor RX Logic
  • Subsystem CSRs
  • Address Decoder
  • AXI-ST Bridge TX Logic/PTP TX
  • AXI-ST Bridge RX Logic/PFC RX Logic
  • AXI-Lite Bridge
  • QHIP
  • NIOS
  • JTAG
  • AN/LT (F-Tile Only)
app_ss_st_txphydirect_areset_n

AXI-ST Bridge TX Logic/PTP TX
app_ss_st_rxphydirect_areset_n

AXI-ST Bridge RX Logic/PFC RX Logic
app_ss_lite_areset_n

AXI-Lite Bridge
i_tx_rst
  • Tile Adaptor TX Logic
  • AXI-ST Bridge TX Logic/ PTP TX
i_rx_rst
  • Tile Adaptor RX Logic
  • AXI-ST Bridge RX Logic/ PFC RX Logic
Level Two Title