Triple-Speed Ethernet Agilex® 7 FPGA IP Design Example User Guide

Download PDF
ID 741330
Date 10/07/2024
Public
Document Table of Contents
Document Table of Contents x
1. Quick Start Guide 2. 10/100/1000 Multiport Ethernet MAC Design Example with 1000BASE-X/SGMII PCS and Embedded PMA 3. Triple-Speed Ethernet Agilex™ 7 FPGA IP Design Example User Guide Archive 4. Document Revision History for the Triple-Speed Ethernet Agilex™ 7 FPGA IP Design Example User Guide
1. Quick Start Guide x
1.1. Directory Structure 1.2. Generating the Design Example 1.3. Simulating the Triple-Speed Ethernet Intel® FPGA IP Design Example Testbench 1.4. Compiling and Configuring the Design Example in Hardware
1.2. Generating the Design Example x
1.2.1. Design Example Parameters
2. 10/100/1000 Multiport Ethernet MAC Design Example with 1000BASE-X/SGMII PCS and Embedded PMA x
2.1. Features 2.2. Hardware and Software Requirements 2.3. Functional Description 2.4. Simulation 2.5. Hardware Testing 2.6. Interface Signals 2.7. Hardware Limitations
2.3. Functional Description x
2.3.1. Design Components 2.3.2. Clock and Reset Signals
2.4. Simulation x
2.4.1. Testbench
2.5. Hardware Testing x
2.5.1. Test Procedure 2.5.2. Design Constraints
1. Quick Start Guide
2. 10/100/1000 Multiport Ethernet MAC Design Example with 1000BASE-X/SGMII PCS and Embedded PMA
3. Triple-Speed Ethernet Agilex™ 7 FPGA IP Design Example User Guide Archive
4. Document Revision History for the Triple-Speed Ethernet Agilex™ 7 FPGA IP Design Example User Guide

1.3. Simulating the Triple-Speed Ethernet Intel® FPGA IP Design Example Testbench

Figure 5. Procedure to Simulate Example Testbench
Follow these steps to simulate the testbench:
  1. Change to the testbench simulation directory <design_example_dir>/example_testbench.
  2. Run the simulation script for the supported simulator of your choice. The script compiles and runs the testbench in the simulator. Refer to the table Steps to Simulate the Testbench.
    Table 4.  Steps to Simulate the Testbench
    Simulator Instructions
    ModelSim* In the command line, type vsim -do run_vsim_mac_pcs.do. If you prefer to simulate without bringing up the ModelSim* GUI, type vsim -c -do run_vsim_mac_pcs.do.
    Synopsys* VCS* / VCS* MX In the command line, type sh run_vcs_mac_pcs.sh or sh run_vcsmx_mac_pcs.sh.
    Xcelium* In the command line, type sh run_xcelium_mac_pcs.sh.
  3. Analyze the results. The successful testbench sends ten packets, receives the same number of packets, and displays the following message: 
End of Simulation - Break
Level Two Title