AN 973: Three-phase Boost Bidirectional AC/DC Converter for Electric Vehicle (EV) Charging

Download PDF
ID 733436
Date 6/23/2022
Public
Document Table of Contents
Document Table of Contents x
1. Three-phase Boost Bidirectional AC/DC Converter for Electric Vehicle (EV) Charging Design Example Overview 2. Downloading and Installing the Design Example 3. Model Description 4. FPGA Resource Use Comparison 5. Locating Top-level VHDL Wrapper 6. Generating HDL Code with MATLAB and HDL Coder 7. Simulink Simulation Results 8. Document Revision History for AN 973: Three-phase Boost Bidirectional AC/DC Converter for EV Charging
2. Downloading and Installing the Design Example x
2.1. Software Requirements 2.2. Hardware Requirements 2.3. Downloading and Installing the Design
3. Model Description x
3.1. Simscape* Model 3.2. Simulink* Model 3.3. HDL Inputs, Outputs, and Parameters
3.2. Simulink* Model x
3.2.1. Controller Block 3.2.2. Power Electronics Block Model 3.2.3. Source Voltage Generator Block
3.2.1. Controller Block x
3.2.1.1. Pulse Width Modulation (PWM) Controller 3.2.1.2. Phase-locked Loop (PLL) 3.2.1.3. Sampling Circuit 3.2.1.4. Clarke and Park Transforms
3.2.2. Power Electronics Block Model x
3.2.2.1. Six-switch Power Converter 3.2.2.2. Inductors 3.2.2.3. Output Capacitor
6. Generating HDL Code with MATLAB and HDL Coder x
6.1. Generating HDL and QPF Using MATLAB Scripts 6.2. Generating HDL and QPF Using MATLAB GUI Tools
1. Three-phase Boost Bidirectional AC/DC Converter for Electric Vehicle (EV) Charging Design Example Overview
2. Downloading and Installing the Design Example
3. Model Description
4. FPGA Resource Use Comparison
5. Locating Top-level VHDL Wrapper
6. Generating HDL Code with MATLAB and HDL Coder
7. Simulink Simulation Results
8. Document Revision History for AN 973: Three-phase Boost Bidirectional AC/DC Converter for EV Charging

3.2.2.2. Inductors

Inductors comprise of three subblocks, and each emulating one of the three inductors. The inductor model has two inputs (the voltage at either end of the inductor) and one output (the current through the inductor).

One end of each inductor is connected to the respective phase of the power grid voltage. The other end of the inductor is connected to the voltage switch. The inductor model integrates the difference between these inputs, multiplied by the inductance, to produce the resulting current through the inductor.

The voltage switch's high and low sides are the output capacitor's respective pins.

Level Two Title