F-Tile CPRI PHY Multirate Intel® FPGA IP User Guide

Download PDF
ID 710578
Date 3/28/2022
Public

A newer version of this document is available. Customers should click here to go to the newest version.

Document Table of Contents
Document Table of Contents x
1. Introduction 2. Interface Overview 3. Parameters 4. Designing with the IP Core 5. Block Description 6. Configuration Registers 7. F-Tile CPRI PHY Multirate Intel FPGA IP User Guide Archives 8. Document Revision History for the F-Tile CPRI PHY Multirate Intel® FPGA IP User Guide
1. Introduction x
1.1. IP Core Overview 1.2. Release Information 1.3. Device Family Support 1.4. Device Speed Grade Support 1.5. Related Documentation
2. Interface Overview x
2.1. Clock Signals 2.2. Reset Signals 2.3. TX MII Interface (64b/66b) 2.4. RX MII Interface (64b/66b) 2.5. Status Interface for 64b/66b Line Rate 2.6. TX Interface (8b/10b) 2.7. RX Interface (8b/10b) 2.8. Status Interface for 8b/10b Line Rate 2.9. Serial Interface 2.10. CPRI PHY Reconfiguration Interface 2.11. Datapath Avalon Memory-Mapped Interface 2.12. PMA Avalon Memory-Mapped Interface
2.1. Clock Signals x
2.1.1. Required Clock Frequencies
3. Parameters x
3.1. Sub Profile Parameters Validation
4. Designing with the IP Core x
4.1. Installing and Licensing Intel® FPGA IP Cores 4.2. Specifying the IP Core Parameters and Options 4.3. Generated File Structure 4.4. Dynamic Reconfiguration Settings
4.1. Installing and Licensing Intel® FPGA IP Cores x
4.1.1. Intel® FPGA IP Evaluation Mode
4.2. Specifying the IP Core Parameters and Options x
4.2.1. Reference and System PLL Clock for your IP Design
5. Block Description x
5.1. Latency Measurement 5.2. CDR Clock Output 5.3. RX PMA Adaptation
5.1. Latency Measurement x
5.1.1. Deterministic Latency 5.1.2. Calculation for 64b/66b Datapath
1. Introduction
2. Interface Overview
3. Parameters
4. Designing with the IP Core
5. Block Description
6. Configuration Registers
7. F-Tile CPRI PHY Multirate Intel FPGA IP User Guide Archives
8. Document Revision History for the F-Tile CPRI PHY Multirate Intel® FPGA IP User Guide

5. Block Description

The following block digram shows the interconnections of F-tile CPRI PHY IP instances that are used as power up instance, and profile instances:
Figure 10. Block Diagram

You specify the common parameter settings across power up and dynamic reconfiguration profiles to configure this IP. Then, you specify the Profile 0 (Power Up) settings. After that, you configure the dynamic reconfiguration profiles (Profile 1 to Profile 11) with parameter settings that are compatible with Profile 0 (Power Up). The IP parameter editor dynamically enforces the compatibility of the dynamic reconfiguration profiles with power up settings.


Section Content
Latency Measurement
CDR Clock Output
RX PMA Adaptation

Level Two Title