F-Tile Ethernet Intel® FPGA Hard IP User Guide

ID 683023
Date 6/20/2022
Public

A newer version of this document is available. Customers should click here to go to the newest version.

Document Table of Contents

9.1.5. Clocks and Resets

Table 69.  Clock and Reset Ports
Name Description
i_clk Clock source with 100 MHz - 250 MHz frequency. When AN/LT is enabled, i_clk can be driven at 1GHz for faster simulation times.
i_reset Active high reset, synchronous to i_clk clock.
Table 70.   Avalon® Memory-Mapped Interface PortsThe interface signals are clocked by the i_clk clock.
Name Width Description
i_kr_reconfig_addr[11:0] 12 Address bus for auto-negotiation and link training control and status registers (AN/LT CSRs).
  • Bits [11:8]: Port number
  • [7:0]: CSR space for each port
i_kr_reconfig_read 1 Read enable for AN/LT CSRs.
i_kr_reconfig_write 1 Write enable for AN/LT CSRs.
i_kr_reconfig_byte_en[3:0] 4 AN/LT byte enable signal for writing data.
i_kr_reconfig_writedata[31:0] 32 Write data for AN/LT CSRs.
o_kr_reconfig_readdata[31:0] 32 Read data from AN/LT CSRs.
o_kr_reconfig_readdata_valid 1 Valid signal for AN/LT CSRs read data. When asserted, the register is valid.
o_kr_reconfig_waitrequest 1 Indicates that the Avalon® memory-mapped interface is busy. The read or write cycle is only complete when this signal goes low.
Table 71.  Base IP Ports Connection
Name Width Description
anlt_link [NUMPORTS_GUI-1:0] Used to connect to NUMPORTS_GUI Ethernet IP Instances. You must connect the port to the anlt_link port of the F-Tile Ethernet Intel® FPGA Hard IP.
Note: This is a virtual wire that carries no signal information used by the Intel® Quartus® Prime Tile Logic Generation flow to correctly connect the AN/LT IP to the Ethernet IP.