F-Tile Triple-Speed Ethernet Intel® FPGA IP User Guide

ID 741328
Date 4/03/2023
Public

A newer version of this document is available. Customers should click here to go to the newest version.

Document Table of Contents

7.1.3.2. Status LED Control Signals

Table 66.  Status LED Interface Signals
Name I/O Description
led_link O When asserted, this signal indicates a successful link synchronization.
led_panel_link O When asserted, this signal indicates the following behavior:
Mode Signal Behavior
1000 Base-X without auto negotiation Similar to led_link
SGMII mode without auto negotiation Similar to led_link
1000 Base-X with auto negotiation Similar to led_an
SGMII mode with MAC mode auto negotiation Similar to led_an and partner_ability [15]
SGMII mode with PHY mode auto negotiation Similar to led_an and dev_ability [15]
led_crs O When asserted, this signal indicates some activities on the transmit and receive paths. When deasserted, it indicates no traffic on the paths.
led_col O When asserted, this signal indicates that a collision was detected during frame transmission. This signal is always deasserted when the PCS function operates in standard 1000BASE-X mode or in full-duplex mode when SGMII is enabled.
led_an O Auto-negotiation status. The PCS function asserts this signal when an auto-negotiation completes.
led_char_err O 10-bit character error. Asserted for one tbi_rx_clk cycle when an erroneous 10-bit character is detected.
led_disp_err O 10-bit running disparity error. Asserted for one tbi_rx_clk cycle when a disparity error is detected. A running disparity error indicates that more than the previous and perhaps the current received group had an error.