2.1.1. Reading Device Information
To read device information:
- Click Hardware Setup to select the hardware setup to use for debugging.
- Click Load Device and select a device from the drop-down list if more than one device exists in the hardware setup.
- Click Device Info for device information reading.
Note: The Device Info tab is disabled if the selected device is not SDM-based.
- Click Read Device Info to read device information for the selected device.
- Device Name
- JTAG ID
- Chip ID
- Boot Status
- Configuration Status:
- State provides the most recent device configuration states.
- Major Error Code provides the major error code for the most recent configuration related error.
- Major Error Type provides the corresponding error type for the major error code.
- Minor Error Code provides the minor error code for the most recent configuration related error.
- Minor Error Type provides the corresponding error type for the minor error code.
- Error Location provides an approximate location of error occurrence in the bitstream. The error location status is helpful when an error occurs in the debugger tool.
- Error Detail provides more information as to where the error has occurred. The error detail status is helpful in conjunction with the error location.
- Error Message provides the corresponding error messages when an error occurs.
- Configuration Pin Signals:
- Most recent device configuration states.
- MSEL value latched by the device at power-up.
- Soft Function Status provides the value for each soft function, even if you have not assigned the function to an SDM pin.
Note: Refer to Table 1 for more details on soft function description.
- Click List of OPN to display all the possible OPNs with the same JTAG ID.
- Click Reset when you wish to reset the page.
Figure 3. Device Information
| Soft Function | Description |
|---|---|
| CONF_DONE | The function status goes high, indicating all configuration data is received. |
| CVP_DONE | The function status goes high, indicating the device has received the complete bitstream during configuration via protocol (CvP) core image configuration. |
| INIT_DONE | The function status goes high, indicating the device enters the user mode upon completion of configuration. |
| SEU_ERROR | The function status goes high, indicating an SEU error message inside the SEU error queue. |
| HPS_COLDRESET | The function status goes high, indicating that HPS is in cold reset. |
| HPS_WARMRESET | The function status goes high, indicating that HPS is in warm reset. |
| POR_WAIT | The function status goes high, indicating the device is waiting for a power cycle. |
| PROVISION_CMF | The function status goes high, indicating the device is running in provision firmware. |
| CMF_TRANSITION_DISABLED | The function status goes high, indicating the device reconfiguration is disabled. You must power cycle the device to recover. |