AN 955: Programmer’s Configuration Debugger Tool

Download PDF
ID 691274
Date 11/04/2021
Public

A newer version of this document is available. Customers should click here to go to the newest version.

Document Table of Contents
Document Table of Contents x
1. Programmer’s Configuration Debugger Tool 2. Debugging Tool Components 3. Document Revision History for AN 955: Programmer’s Configuration Debugger Tool
1. Programmer’s Configuration Debugger Tool x
1.1. Launching Debugger Tool
2. Debugging Tool Components x
2.1. Getting Device Information 2.2. Debugging QSPI Flash 2.3. Debugging Remote System Update 2.4. Parsing Programming Files
2.1. Getting Device Information x
2.1.1. Reading Device Information
2.2. Debugging QSPI Flash x
2.2.1. Performing QSPI Flash Debugging
2.3. Debugging Remote System Update x
2.3.1. Performing Remote System Update Debugging
2.4. Parsing Programming Files x
2.4.1. Reading Programming File Information 2.4.2. Parsing Program Files Command Option 2.4.3. Programming File Formats
2.4.3. Programming File Formats x
2.4.3.1. SOF File Information 2.4.3.2. RBF File Information 2.4.3.3. PMSF File Information
1. Programmer’s Configuration Debugger Tool
2. Debugging Tool Components
3. Document Revision History for AN 955: Programmer’s Configuration Debugger Tool

2.2.1. Performing QSPI Flash Debugging

To perform QSPI flash debugging:
  1. Click Hardware Setup to select the hardware setup to use for debugging.
  2. Click Load Device and select a device from the drop-down list if more than one device exists in the hardware setup.
  3. Click Flash.
    Note: The Flash tab is disabled if the selected device is not SDM-based.
  4. Click Auto-detect to auto-detect the QSPI Flash that is attached to the device.
  5. Click QSPI Flash.
  6. Click Read Registers to start reading the flash registers with the specified OPCODE and Number of Bytes.
  7. Click Read Memory to start reading the flash memory for the specified Start Address and Number of Words.
  8. Click Save Read Data to RPD to save the read data to a RPD file.
  9. Click Write Memory to write the specified data to the specified address.
  10. Click Erase Sectors to erase the flash memory from the specified Sector Start Address and Number of sectors to erase.
  11. Click ... (ellipsis) to upload a RPD file that programs the flash memory from a specified start address.
  12. Click Program RPD to start the flash programming with data from a RPD file.
  13. Click Reset when you wish to reset the page.
Figure 4. QSPI Flash
Level Two Title