F-Tile Ethernet Intel® FPGA Hard IP Design Example User Guide

ID 683804
Date 7/09/2024
Public
Document Table of Contents

1.3. Simulating the Design Example Testbench

You can compile and simulate the design by running a simulation script from the command prompt.
Figure 8. Procedure
  1. At the command prompt, change the working directory to <design_example_dir>/example_testbench.
  2. Run the simulation script for the supported simulator of your choice. The script compiles and runs the testbench in the simulator. Refer to the table Steps to Simulate the Testbench.
  3. Analyze the results. The successful testbench displays "Simulation Passed".
    Table 5.  Steps to Simulate the Testbench
    Simulator Instructions
    Synopsys* VCS* In the command line, type:
    sh run_vcs.sh
    Synopsys* VCS* MX In the command line, type:
    sh run_vcsmx.sh

    Use this script when the design contains Verilog HDL and System Verilog with VHDL.

    ModelSim* SE or QuestaSim* or Questa* Intel® FPGA Edition In the command line, type:
    vsim -do run_vsim.do
    If you prefer to simulate without bringing up the GUI, type:
    vsim -c -do run_vsim.do
    Xcelium* In the command line, type:
    sh run_xcelium.sh
    Aldec Riviera-PRO* 1 In the command line, type
    vsim -c -do run_rivierasim.do
A successful simulation ends with the following message:
Simulation Passed.
or
Testbench complete.
After successful completion, you can analyze the results.
1 Only Riviera 2022.10 is supported