Intel® Agilex™ Device Configuration via Protocol (CvP) Implementation User Guide

ID 683763
Date 9/26/2022
Public

A newer version of this document is available. Customers should click here to go to the newest version.

Document Table of Contents

1.2. CvP System

A CvP system typically consists of an FPGA, a PCIe* host, and a configuration device.
Figure 1. CvP Block Diagram
  1. The FPGA connects to the configuration device using the Active Serial x4 (fast mode) configuration scheme.
  2. For devices that support only one PCIe Hard IP block on the left, the lower left PCIe Hard IP block is used for CvP application.
  3. For devices that support two or more PCIe Hard IP block on the left, CvP application can use either top or bottom of the PCIe Hard IP blocks on the left side.
  4. PCIe Hard IP blocks that are not used for CvP can be used for PCIe application.
Note: For PCIe design including Configuration via Protocol (CvP), Intel recommends you to use Micron QSPI flash in order to load the initial configuration firmware faster to meet the PCIe wake up time for host enumeration. This is because boot ROM reads the initial configuration firmware using x4 mode when using the Micron QSPI flash. For a non-Micron flash, the boot ROM reads the firmware using x1 mode. If you need to use the non-Micron QSPI flash for PCIe design, Intel recommends you to assert PERST# signal low for a minimum of 200 ms from the FPGA POR to ensure the PCIe end point enter link training state before PERST# deasserted.