Visible to Intel only — GUID: dkm1574822625300
Ixiasoft
1. HDMI Intel® FPGA IP Design Example Quick Start Guide for Stratix® 10 Devices
2. HDMI 2.1 Design Example (Support FRL = 1)
3. HDMI 2.0 Design Example
4. HDCP Over HDMI 2.0/2.1 Design Example
5. HDMI Stratix® 10 FPGA IP Design Example User Guide Archives
6. Document Revision History for the HDMI Stratix® 10 FPGA IP Design Example User Guide
Features
2.1. HDMI 2.1 RX-TX Retransmit Design Block Diagram
2.2. Creating RX-Only or TX-Only Designs
2.3. Hardware and Software Requirements
2.4. Directory Structure
2.5. Design Components
2.6. Dynamic Range and Mastering (HDR) InfoFrame Insertion and Filtering
2.7. Design Software Flow
2.8. Running the Design in Different FRL Rates
2.9. Clocking Scheme
2.10. Interface Signals
2.11. Design RTL Parameters
2.12. Hardware Setup
2.13. Simulation Testbench
2.14. Design Limitations
2.15. Debugging Features
3.1. HDMI RX-TX Retransmit Design Block Diagram
3.2. Creating TX or RX Only Designs
3.3. Design Components
3.4. Dynamic Range and Mastering (HDR) InfoFrame Insertion and Filtering
3.5. Clocking Scheme
3.6. Interface Signals
3.7. Design RTL Parameters
3.8. Hardware Setup
3.9. Simulation Testbench
3.10. Upgrading Your Design
Visible to Intel only — GUID: dkm1574822625300
Ixiasoft
2. HDMI 2.1 Design Example (Support FRL = 1)
The HDMI 2.1 design example in FRL mode demonstrates one HDMI instance parallel loopback comprising four RX channels and four TX channels.
Design Example | Data Rate | Channel Mode | Loopback Type |
---|---|---|---|
Stratix10 HDMI RX-TX Retransmit |
|
Simplex | Parallel with FIFO buffer |
Features
- The design instantiates FIFO buffers to perform a direct HDMI video stream passthrough between the HDMI 2.1 sink and source.
- The design is capable to switch between FRL mode and TMDS mode during run time.
- The design uses LED status for early debugging stage.
- The design comes with HDMI RX and TX instances.
- The design demonstrates the insertion and filtering of Dynamic Range and Mastering (HDR) InfoFrame in RX-TX link module.
- The design negotiates the FRL rate between the sink connected to TX and the source connected to RX. The design passes through the EDID from the external sink to the on-board RX in default configuration. The Nios® V processor negotiates the link base on the capability of the sink connected to TX. You can also toggle the user_dipsw on-board switch to manually control the TX and RX FRL capabilities.
- The design includes several debugging features.
Section Content
HDMI 2.1 RX-TX Retransmit Design Block Diagram
Creating RX-Only or TX-Only Designs
Hardware and Software Requirements
Directory Structure
Design Components
Dynamic Range and Mastering (HDR) InfoFrame Insertion and Filtering
Design Software Flow
Running the Design in Different FRL Rates
Clocking Scheme
Interface Signals
Design RTL Parameters
Hardware Setup
Simulation Testbench
Design Limitations
Debugging Features