AN 100: In-System Programmability Guidelines

Download PDF
ID 683546
Date 9/22/2014
Public
Document Table of Contents
Document Table of Contents x
1. In-System Programmability Guidelines
1. In-System Programmability Guidelines x
1.1. General ISP Guideline 1.2. IEEE Std. 1149.1 Signals 1.3. Sequential versus Concurrent Programming 1.4. ISP Troubleshooting Guidelines 1.5. ISP through Embedded Processors 1.6. ISP through In-Circuit Testers 1.7. Document Revision History
1.1. General ISP Guideline x
1.1.1. Operating Conditions 1.1.2. User Flash Memory Operations During In-System Programming 1.1.3. Interrupting In-System Programming 1.1.4. MultiVolt Devices and Power-Up Sequences 1.1.5. I/O Pins Tri-Stated During In-System Programming 1.1.6. Pull-Up and Pull-Down of JTAG Pins During In-System Programming
1.1.1. Operating Conditions x
1.1.1.1. ISP Voltage 1.1.1.2. Input Voltages
1.2. IEEE Std. 1149.1 Signals x
1.2.1. TCK Signal 1.2.2. Programming Through a Download Cable 1.2.3. Disabling IEEE Std. 1149.1 Circuitry 1.2.4. Working with Different Voltage Levels
1.3. Sequential versus Concurrent Programming x
1.3.1. Sequential Programming 1.3.2. Concurrent Programming 1.3.3. Selecting Sequential or Concurrent Programming 1.3.4. Devices in Different Modes
1.4. ISP Troubleshooting Guidelines x
1.4.1. Invalid ID and Unrecognized Device Messages 1.4.2. Verify the JTAG Chain Continuity 1.4.3. Check the Voltage Levels of the Board During In-System Programming 1.4.4. Random Signals on JTAG Pins 1.4.5. Software Issues
1.5. ISP through Embedded Processors x
1.5.1. Processor and Memory Requirements 1.5.2. Porting the Jam Player
1. In-System Programmability Guidelines

1.1. General ISP Guideline

The are several guidelines that will help you to design successfully for ISP-capable devices. You must use these guidelines regardless of your specific design implementation.

The following lists the guidelines:

  • Operating Conditions
  • User Flash Memory Operations During In-System Programming
  • Interrupting In-System Programming
  • MultiVolt Devices and Power-Up Sequences
  • I/O Pins Tri-Stated During In-System Programming
  • Pull-Up and Pull-Down of JTAG Pins During In-System Programming

Section Content
Operating Conditions
User Flash Memory Operations During In-System Programming
Interrupting In-System Programming
MultiVolt Devices and Power-Up Sequences
I/O Pins Tri-Stated During In-System Programming
Pull-Up and Pull-Down of JTAG Pins During In-System Programming

Level Two Title