AN 820: Hierarchical Partial Reconfiguration over PCI Express* Reference Design for Intel® Stratix® 10 Devices

Download PDF
ID 683531
Date 9/24/2018
Public
Document Table of Contents
Document Table of Contents x
1. Hierarchical Partial Reconfiguration over PCI Express* Reference Design for Intel® Stratix® 10 Devices A. Reference Design Files
1. Hierarchical Partial Reconfiguration over PCI Express* Reference Design for Intel® Stratix® 10 Devices x
1.1. Reference Design Overview 1.2. Getting Started 1.3. Reference Design Components 1.4. Compiling the Reference Design 1.5. Testing the Reference Design 1.6. Extending the Reference Design with Custom Persona 1.7. Document Revision History for AN 820: Hierarchical Partial Reconfiguration over PCI Express* Reference Design for Intel® Stratix® 10 Devices
1.1. Reference Design Overview x
1.1.1. Clocking Scheme 1.1.2. Memory Address Mapping 1.1.3. Floorplanning
1.2. Getting Started x
1.2.1. Hardware and Software Requirements 1.2.2. Installing the Intel® Stratix® 10 GX FPGA Development Kit 1.2.3. Installing the Linux Driver 1.2.4. Bringing Up the Reference Design
1.3. Reference Design Components x
1.3.1. BSP Top
1.3.1. BSP Top x
1.3.1.1. PCI Express* IP core 1.3.1.2. Intel® Stratix® 10 DDR4 External Memory Interfaces IP Core 1.3.1.3. Design Top
1.3.1.3. Design Top x
1.3.1.3.1. Global Reset Logic 1.3.1.3.2. PR Region Wrapper 1.3.1.3.3. Intel® Stratix® 10 Partial Reconfiguration Region Controller IP Core 1.3.1.3.4. Intel® Stratix® 10 Partial Reconfiguration Controller IP Core 1.3.1.3.5. Partial Reconfiguration Logic
1.5. Testing the Reference Design x
1.5.1. program_fpga_jtag 1.5.2. fpga-configure example_host_uio
example_host_uio x
1.5.3.1. Compiling the Example Applications 1.5.3.2. Programming the Design Using Example Applications
1. Hierarchical Partial Reconfiguration over PCI Express* Reference Design for Intel® Stratix® 10 Devices
A. Reference Design Files

1.2.2. Installing the Intel® Stratix® 10 GX FPGA Development Kit

For complete instructions on installing and powering the Intel® Stratix® 10 GX FPGA development board in your Linux system, refer to Intel® Stratix® 10 FPGA Development Kit User Guide.
Important:
  • When bringing up the design for the first time, ensure that you configure the DIP switch 1 (SW1) with both jumpers in the UP position. The switches are reverted to the standard (UP, DOWN) position after flashing the device.
  • Before powering the board, set the switch 4 (FACTORY) of the DIP switch bank (SW6) to ON. Setting this switch to ON loads the factory image area of the flash memory at boot time. Program the reference design into this factory image area. For complete instructions on flashing the reference design onto the board, refer to Bringing Up the Reference Design.
Related Information
Level Two Title