Visible to Intel only — GUID: bhc1395127736645
Ixiasoft
1. About LL Ethernet 10G MAC
2. Getting Started
3. LL Ethernet 10G MAC Intel® FPGA IP Design Examples
4. Functional Description
5. Configuration Registers
6. Interface Signals
7. Low Latency Ethernet 10G MAC Intel® FPGA IP User Guide Archives
8. Document Revision History for the Low Latency Ethernet 10G MAC Intel® FPGA IP User Guide
2.1. Introduction to Intel® FPGA IP Cores
2.2. Installing and Licensing Intel® FPGA IP Cores
2.3. Specifying the IP Core Parameters and Options ( Quartus® Prime Pro Edition)
2.4. IP Core Generation Output ( Quartus® Prime Pro Edition)
2.5. Files Generated for Intel IP Cores (Legacy Parameter Editor)
2.6. Simulating Intel® FPGA IP Cores
2.7. Creating a Signal Tap Debug File to Match Your Design Hierarchy
2.8. Parameter Settings for the Low Latency Ethernet 10G MAC Intel® FPGA IP Core
2.9. Upgrading the Low Latency Ethernet 10G MAC Intel® FPGA IP Core
2.10. Design Considerations for the Low Latency Ethernet 10G MAC Intel® FPGA IP Core
5.1. Register Map
5.2. Register Access Definition
5.3. Primary MAC Address
5.4. MAC Reset Control Register
5.5. TX Configuration and Status Registers
5.6. Flow Control Registers
5.7. Unidirectional Control Registers
5.8. RX Configuration and Status Registers
5.9. Timestamp Registers
5.10. ECC Registers
5.11. Statistics Registers
6.1. Clock and Reset Signals
6.2. Speed Selection Signal
6.3. Error Correction Signals
6.4. Unidirectional Signals
6.5. Avalon® Memory-Mapped Interface Programming Signals
6.6. Avalon® Streaming Data Interfaces
6.7. Avalon® Streaming Flow Control Signals
6.8. Avalon® Streaming Status Interface
6.9. PHY-side Interfaces
6.10. IEEE 1588v2 Interfaces
Visible to Intel only — GUID: bhc1395127736645
Ixiasoft
4.10.2. TX Datapath
The IEEE 1588v2 feature supports 1-step and 2-step clock synchronizations on the TX datapath.
- For 1-step clock synchronization,
- Timestamp insertion depends on the PTP device and message type.
- The MAC function inserts a timestamp in the PTP packet when the client specifies the Timestamp field offset and asserts Timestamp Insert Request.
- Depending on the PTP device and message type, the MAC function updates the residence time in the correction field of the PTP packet when the client asserts tx_etstamp_ins_ctrl_residence_time_update and Correction Field Update. The residence time is the difference between the egress and ingress timestamps.
- For PTP packets encapsulated using the UDP/IPv6 protocol, the MAC function performs UDP checksum correction using extended bytes in the PTP packet.
- The MAC function recomputes and reinserts CRC-32 into PTP packets each time the timestamp or correction field is updated, even when CRC insertion is disabled using the tx_crc_control[1] register bit.
- The format of timestamp supported includes 1588v1 and 1588v2.
- The MAC function updates tx_egress_p2p_val[45:0] into correction field of PTP packet when the client asserts tx_egress_p2p_update.
- The MAC function updates asymmetry value into correction field of PTP packet when the client asserts tx_egress_asymmetry_update. The asymmetry value is retrieved from configuration registers.
- For 2-step clock synchronization, the MAC function returns the timestamp and the associated fingerprint for all TX frames when the client asserts tx_egress_timestamp_request_valid.
The following table summarizes the timestamp and correction field insertions for various PTP messages in different PTP clocks.
PTP Message | Ordinary Clock | Boundary Clock | E2E Transparent Clock | P2P Transparent Clock | ||||
---|---|---|---|---|---|---|---|---|
Insert Time stamp | Insert Correction | Insert Time stamp | Insert Correction | Insert Time stamp | Insert Correction | Insert Time stamp | Insert Correction | |
Sync | Yes 5 | No | Yes5 | No | No | Yes 6 | No | Yes 6 |
Delay_Req | No | No | No | No | No | Yes 6 | No | No |
Pdelay_Req | No | No | No | No | No | Yes 6 | No | No |
Pdelay_Resp | No | Yes 5 6 | No | Yes 5 6 | No | Yes 6 | No | Yes 5 6 |
Delay_Resp | No | No | No | No | No | No | No | No |
Follow_Up | No | No | No | No | No | No | No | No |
Pdelay_Resp_ Follow_Up |
No | No | No | No | No | No | No | No |
Announce | No | No | No | No | No | No | No | No |
Signaling | No | No | No | No | No | No | No | No |
Management | No | No | No | No | No | No | No | No |
5 Applicable only when 2-step flag in flagField of the PTP packet is 0.
6 Applicable when you assert the tx_etstamp_ins_ctrl_residence_time_update signal.