Visible to Intel only — GUID: nfa1461051395599
Ixiasoft
1. About LL Ethernet 10G MAC
2. Getting Started
3. LL Ethernet 10G MAC Intel® FPGA IP Design Examples
4. Functional Description
5. Configuration Registers
6. Interface Signals
7. Low Latency Ethernet 10G MAC Intel® FPGA IP User Guide Archives
8. Document Revision History for the Low Latency Ethernet 10G MAC Intel® FPGA IP User Guide
2.1. Introduction to Intel® FPGA IP Cores
2.2. Installing and Licensing Intel® FPGA IP Cores
2.3. Specifying the IP Core Parameters and Options ( Quartus® Prime Pro Edition)
2.4. IP Core Generation Output ( Quartus® Prime Pro Edition)
2.5. Files Generated for Intel IP Cores (Legacy Parameter Editor)
2.6. Simulating Intel® FPGA IP Cores
2.7. Creating a Signal Tap Debug File to Match Your Design Hierarchy
2.8. Parameter Settings for the Low Latency Ethernet 10G MAC Intel® FPGA IP Core
2.9. Upgrading the Low Latency Ethernet 10G MAC Intel® FPGA IP Core
2.10. Design Considerations for the Low Latency Ethernet 10G MAC Intel® FPGA IP Core
5.1. Register Map
5.2. Register Access Definition
5.3. Primary MAC Address
5.4. MAC Reset Control Register
5.5. TX Configuration and Status Registers
5.6. Flow Control Registers
5.7. Unidirectional Control Registers
5.8. RX Configuration and Status Registers
5.9. Timestamp Registers
5.10. ECC Registers
5.11. Statistics Registers
6.1. Clock and Reset Signals
6.2. Speed Selection Signal
6.3. Error Correction Signals
6.4. Unidirectional Signals
6.5. Avalon® Memory-Mapped Interface Programming Signals
6.6. Avalon® Streaming Data Interfaces
6.7. Avalon® Streaming Flow Control Signals
6.8. Avalon® Streaming Status Interface
6.9. PHY-side Interfaces
6.10. IEEE 1588v2 Interfaces
Visible to Intel only — GUID: nfa1461051395599
Ixiasoft
7. Low Latency Ethernet 10G MAC Intel® FPGA IP User Guide Archives
For the latest and previous versions of this user guide, refer to Low Latency Ethernet 10G MAC Intel FPGA IP User Guide. If an IP or software version is not listed, the user guide for the previous IP or software version applies.
IP versions are the same as the Quartus® Prime Design Suite software versions up to v19.1. From Quartus® Prime Design Suite software version 19.2 or later, IP cores have a new IP versioning scheme.