Visible to Intel only — GUID: bhc1417759240203
Ixiasoft
1. About LL Ethernet 10G MAC
2. Getting Started
3. LL Ethernet 10G MAC Intel® FPGA IP Design Examples
4. Functional Description
5. Configuration Registers
6. Interface Signals
7. Low Latency Ethernet 10G MAC Intel® FPGA IP User Guide Archives
8. Document Revision History for the Low Latency Ethernet 10G MAC Intel® FPGA IP User Guide
2.1. Introduction to Intel® FPGA IP Cores
2.2. Installing and Licensing Intel® FPGA IP Cores
2.3. Specifying the IP Core Parameters and Options ( Quartus® Prime Pro Edition)
2.4. IP Core Generation Output ( Quartus® Prime Pro Edition)
2.5. Files Generated for Intel IP Cores (Legacy Parameter Editor)
2.6. Simulating Intel® FPGA IP Cores
2.7. Creating a Signal Tap Debug File to Match Your Design Hierarchy
2.8. Parameter Settings for the Low Latency Ethernet 10G MAC Intel® FPGA IP Core
2.9. Upgrading the Low Latency Ethernet 10G MAC Intel® FPGA IP Core
2.10. Design Considerations for the Low Latency Ethernet 10G MAC Intel® FPGA IP Core
5.1. Register Map
5.2. Register Access Definition
5.3. Primary MAC Address
5.4. MAC Reset Control Register
5.5. TX Configuration and Status Registers
5.6. Flow Control Registers
5.7. Unidirectional Control Registers
5.8. RX Configuration and Status Registers
5.9. Timestamp Registers
5.10. ECC Registers
5.11. Statistics Registers
6.1. Clock and Reset Signals
6.2. Speed Selection Signal
6.3. Error Correction Signals
6.4. Unidirectional Signals
6.5. Avalon® Memory-Mapped Interface Programming Signals
6.6. Avalon® Streaming Data Interfaces
6.7. Avalon® Streaming Flow Control Signals
6.8. Avalon® Streaming Status Interface
6.9. PHY-side Interfaces
6.10. IEEE 1588v2 Interfaces
Visible to Intel only — GUID: bhc1417759240203
Ixiasoft
2.10.2.3. Dual Clock FIFO
The bit skew of the dual clock FIFO gray-coded pointers must be within one 312.5 MHz clock period.
The timing constraint file uses the set_net_delay to constraint the fitter placement and set_max_skew to perform timing check on the paths. For a project with very high device utilization, Intel recommends that you implement addition steps like floor planning or Logic Lock to aid the place-and-route process. The additional steps can give a more consistent timing closure along these paths instead of only relying on the set_net_delay.