Visible to Intel only — GUID: bhc1395127707559
Ixiasoft
1. About LL Ethernet 10G MAC
2. Getting Started
3. LL Ethernet 10G MAC Intel® FPGA IP Design Examples
4. Functional Description
5. Configuration Registers
6. Interface Signals
7. Low Latency Ethernet 10G MAC Intel® FPGA IP User Guide Archives
8. Document Revision History for the Low Latency Ethernet 10G MAC Intel® FPGA IP User Guide
2.1. Introduction to Intel® FPGA IP Cores
2.2. Installing and Licensing Intel® FPGA IP Cores
2.3. Specifying the IP Core Parameters and Options ( Quartus® Prime Pro Edition)
2.4. IP Core Generation Output ( Quartus® Prime Pro Edition)
2.5. Files Generated for Intel IP Cores (Legacy Parameter Editor)
2.6. Simulating Intel® FPGA IP Cores
2.7. Creating a Signal Tap Debug File to Match Your Design Hierarchy
2.8. Parameter Settings for the Low Latency Ethernet 10G MAC Intel® FPGA IP Core
2.9. Upgrading the Low Latency Ethernet 10G MAC Intel® FPGA IP Core
2.10. Design Considerations for the Low Latency Ethernet 10G MAC Intel® FPGA IP Core
5.1. Register Map
5.2. Register Access Definition
5.3. Primary MAC Address
5.4. MAC Reset Control Register
5.5. TX Configuration and Status Registers
5.6. Flow Control Registers
5.7. Unidirectional Control Registers
5.8. RX Configuration and Status Registers
5.9. Timestamp Registers
5.10. ECC Registers
5.11. Statistics Registers
6.1. Clock and Reset Signals
6.2. Speed Selection Signal
6.3. Error Correction Signals
6.4. Unidirectional Signals
6.5. Avalon® Memory-Mapped Interface Programming Signals
6.6. Avalon® Streaming Data Interfaces
6.7. Avalon® Streaming Flow Control Signals
6.8. Avalon® Streaming Status Interface
6.9. PHY-side Interfaces
6.10. IEEE 1588v2 Interfaces
Visible to Intel only — GUID: bhc1395127707559
Ixiasoft
4.6.1. IEEE 802.3 Flow Control
To use the IEEE 802.3 flow control, set the following registers:
- On the TX datapath:
- Set tx_pfc_priority_enable[7:0] to 0 to disable the PFC. The rest of the bits are unused.
- Set tx_pauseframe_enable[0] to 1 to enable the IEEE 802.3 flow control.
- On the RX datapath:
- Set rx_pfc_control[7:0] to 1 to disable the PFC. The rest of the bits are mostly unused.
- Set the IGNORE_PAUSE bit in the rx_frame_control register to 0 to enable the IEEE 802.3 flow control.