Visible to Intel only — GUID: yhq1481305317273
Ixiasoft
1. Overview of the Design Guidelines for Cyclone® V SoC FPGAs and Arria® V SoC FPGAs
2. Background: Comparison between Cyclone® V SoC FPGA and Arria® V SoC FPGA HPS Subsystems
3. Design Guidelines for HPS portion of SoC FPGAs
4. Board Design Guidelines for SoC FPGAs
5. Embedded Software Design Guidelines for SoC FPGAs
A. Support and Documentation
B. Additional Information
4.2.1.1. Boot Source
4.2.1.2. Select Desired Flash Device
4.2.1.3. BSEL Options
4.2.1.4. Boot Clock
4.2.1.5. CSEL Options
4.2.1.6. Selecting NAND Flash Devices
4.2.1.7. Determine Flash Programming Method
4.2.1.8. For QSPI and SD/MMC/eMMC Provide Flash Memory Reset
4.2.1.9. Selecting QSPI Flash Devices
4.5.1. HPS EMAC PHY Interfaces
4.5.2. USB Interface Design Guidelines
4.5.3. QSPI Flash Interface Design Guidelines
4.5.4. SD/MMC and eMMC Card Interface Design Guidelines
4.5.5. NAND Flash Interface Design Guidelines
4.5.6. UART Interface Design Guidelines
4.5.7. I2C Interface Design Guidelines
4.5.8. SPI Interface Design Guidelines
5.1.1. Assembling the Components of Your Software Development Platform
5.1.2. Selecting an Operating System for Your Application
5.1.3. Assembling your Software Development Platform for Linux
5.1.4. Assembling a Software Development Platform for a Bare-Metal Application
5.1.5. Assembling your Software Development Platform for a Partner OS or RTOS
5.1.6. Choosing Boot Loader Software
5.1.7. Selecting Software Tools for Development, Debug and Trace
5.5.1.1. Enable Runtime Calibration Report
5.5.1.2. Change DLEVEL To Get More Debug Information
5.5.1.3. Enable Example Driver for HPS SDRAM
5.5.1.4. Change Data Pattern in Example Driver
5.5.1.5. Example Code to Write and Read from All Addresses
5.5.1.6. Read/Write to HPS Register in Preloader
5.5.1.7. Check HPS PLL Lock Status in Preloader
Visible to Intel only — GUID: yhq1481305317273
Ixiasoft
4.2.2. Configuration
The Cyclone® V / Arria® V SoC devices support two main type sof configuration flows:
- Traditional FPGA configuration
- HPS-initiated FPGA configuration
HPS-initiated configuration uses fast passive parallel (FPP) mode allowing the HPS to configure the FPGA using storage locations accessible to the HPS such as QSPI, SD/MMC and NAND flash. The FPGA configuration flows for the Cyclone® V/ Arria® V SoC are the same for the Cyclone® V/ Arria® V FPGA devices where an external configuration data source is connected to the control block in the FPGA.