Ethernet Design Example Components User Guide

Download PDF
ID 683044
Date 4/01/2024
Public
Document Table of Contents
Document Table of Contents x
1. Time-of-day Clock 2. Time-of-day Synchronizer 3. Packet Classifier 4. Ethernet Design Example Components User Guide Archives 5. Document Revision History for the Ethernet Design Example Components User Guide
1. Time-of-day Clock x
1.1. Release Information 1.2. Resource Utilization 1.3. Configuring the TOD Clock 1.4. Using the TOD Clock 1.5. Interface Signals 1.6. Configuration Registers
1.1. Release Information x
1.1.1. Pulse Per Second Device Speed Grade Support
1.4. Using the TOD Clock x
1.4.1. Adjusting TOD Drift 1.4.2. Adjusting Offset, Jitter, and Wander 1.4.3. Correcting TOD Offset 1.4.4. IOPLL and TOD Setup for Pulse Per Second (Advanced Accuracy Mode)
1.4.4. IOPLL and TOD Setup for Pulse Per Second (Advanced Accuracy Mode) x
1.4.4.1. IOPLL and TOD Setup using Dynamic Phase Shift Interface 1.4.4.2. IOPLL and TOD Setup using IOPLL Reconfig IP
1.5. Interface Signals x
1.5.1. Avalon Memory-Mapped Signals 1.5.2. Time-of-day Signals 1.5.3. Pulse-Per-Second Signals 1.5.4. Clocking Requirements
2. Time-of-day Synchronizer x
2.1. Release Information 2.2. Resource Utilization 2.3. Configuring the TOD Synchronizer 2.4. Using the TOD Synchronizer 2.5. Interface Signals
2.4. Using the TOD Synchronizer x
2.4.1. Sampling Clock Frequency
3. Packet Classifier x
3.1. Release Information 3.2. Resource Utilization 3.3. Configuring the Packet Classifier 3.4. Interface Signals
3.4. Interface Signals x
3.4.1. Clock and Reset Signals 3.4.2. Avalon® Streaming Interface Signals 3.4.3. Control Signals
1. Time-of-day Clock
2. Time-of-day Synchronizer
3. Packet Classifier
4. Ethernet Design Example Components User Guide Archives
5. Document Revision History for the Ethernet Design Example Components User Guide

2.4. Using the TOD Synchronizer

Figure 4. TOD Synchronizer in a Design (SYNC_MODE 0 to 15)
Figure 5. TOD Synchronizer in a Design (SYNC_MODE 18)

The TOD synchronizer with SYNC_MODE = 0 to 15 uses a dual-clock FIFO buffer to receive the time of day from the master TOD clock and transmits it to the target TOD clock. To ensure that the synchronization is accurate, the transfer latency must be taken into consideration. The sampling clock (clk_sampling) samples the fill level of the FIFO buffer and calculates the latency. Derive this clock signal from the same source as the master TOD clock or the target TOD clock using a PLL.

The sampling clock (clk_sampling) is not required for TOD synchronizer with SYNC_MODE = 18 as it uses a different technique for synchronization.


Section Content
Sampling Clock Frequency

Level Two Title