AN 953: Partially Reconfiguring a Design: on an Intel® Agilex® F-Series FPGA Development Board

Download PDF
ID 683849
Date 7/23/2021
Public

A newer version of this document is available. Customers should click here to go to the newest version.

Document Table of Contents
Document Table of Contents x
Partially Reconfiguring a Design on Intel® Agilex® F-Series FPGA Development Board
Partially Reconfiguring a Design on Intel® Agilex® F-Series FPGA Development Board x
Reference Design Overview Reference Design Requirements Reference Design Files Reference Design Walkthrough Document Revision History for AN 953: Partially Reconfiguring a Design on Intel® Agilex® F-Series FPGA Development Board
Reference Design Walkthrough x
Step 1: Getting Started Step 2: Creating a Design Partition Step 3: Allocating Placement and Routing Region for a PR Partition Step 4: Defining Personas Step 5: Creating Revisions Step 6: Compiling the Base Revision Step 7: Preparing PR Implementation Revisions Step 8: Programming the Board Modifying an Existing Persona Adding a New Persona to the Design
Step 5: Creating Revisions x
Setting the Base Revision Type Creating Implementation Revisions
Step 8: Programming the Board x
Troubleshooting PR Programming Errors
Partially Reconfiguring a Design on Intel® Agilex® F-Series FPGA Development Board

Step 8: Programming the Board

This tutorial uses an Intel® Agilex® F-Series FPGA development board on the bench, outside of the PCIe* slot in your host machine. Before you program the board, ensure that you have completed the following steps:

  1. Connect the power supply to the Intel® Agilex® F-Series FPGA development board.
  2. Connect the Intel® FPGA Download Cable between your PC USB port and the Intel® FPGA Download Cable port on the development board.

To run the design on the Intel® Agilex® F-Series FPGA development board:

  1. Open the Intel® Quartus® Prime software and click Tools > Programmer.
  2. In the Programmer, click Hardware Setup and select USB-Blaster.
  3. Click Auto Detect and select the device, AGFB014R24AR0.
  4. Click OK. The Intel® Quartus® Prime software detects and updates the Programmer with the three FPGA devices on the board.
  5. Select the AGFB014R24AR0 device, click Change File and load the blinking_led_default.sof file.
  6. Enable Program/Configure for blinking_led_default.sof file.
  7. Click Start and wait for the progress bar to reach 100%.
  8. Observe the LEDs on the board blinking at the same frequency as the original flat design.
  9. To program only the PR region, right-click the blinking_led_default.sof file in the Programmer and click Add PR Programming File.
  10. Select the blinking_led_slow.pr_partition.rbf file.
  11. Disable Program/Configure for blinking_led_default.sof file.
  12. Enable Program/Configure for blinking_led_slow.pr_partition.rbf file and click Start. On the board, observe LED[0] and LED[1] continuing to blink. When the progress bar reaches 100%, LED[2] and LED[3] blink slower.
  13. To reprogram the PR region, right-click the .rbf file in the Programmer and click Change PR Programing File.
  14. Select the .rbf files for the other two personas to observe the behavior on the board. Loading the blinking_led_default.rbf file causes the LEDs to blink at a specific frequency, and loading the blinking_led_empty.rbf file causes the LEDs to stay ON.
Figure 10. Programming the Intel® Agilex® F-Series FPGA Development Board

Section Content
Troubleshooting PR Programming Errors

Level Two Title