Cyclone® V SX, ST and SE SoC Device Errata

Download PDF
ID 683618
Date 9/25/2015
Public
Document Table of Contents
Document Table of Contents x
1. Cyclone® V SX, ST and SE SoC Device Errata
1. Cyclone® V SX, ST and SE SoC Device Errata x
1.1. Intel® -Specific SoC Errata for Cyclone® V SX, ST, and SE SoC Devices 1.2. Arm* Cortex* -A9 MPCore* and L2 Cache Errata 1.3. Revision History for Cyclone® V SX, ST, and SE SoC Device Errata
1.1. Intel® -Specific SoC Errata for Cyclone® V SX, ST, and SE SoC Devices x
1.1.1. Hard Processor System (HPS) 1.1.2. FPGA
1.1.1. Hard Processor System (HPS) x
1.1.1.1. EMAC RMII PHY Interface is Only Supported Through the FPGA Fabric 1.1.1.2. Hard Processor System Level 2 Cache Error Correction Code 1.1.1.3. Hard Processor System PLL Lock Issue After Power-on Reset or Cold Reset 1.1.1.4. HPS TAP Controller Is Reset By Cold Reset 1.1.1.5. SPI Slave Output Signals Cannot Be Isolated When Routed to the HPS Pins
1.1.2. FPGA x
1.1.2.1. External Memory Interface (EMIF) Maximum Frequency Specification Updage 1.1.2.2. Fractional PLL Phase Alignment Error 1.1.2.3. Power Connection Recommendation for Cyclone® V SoC ES Devices 1.1.2.4. Configuration via Protocol (CvP) 1.1.2.5. Usermode High Icc 1.1.2.6. False Configuration Failure in Active Serial Multi-Device Configuration x1 Mode 1.1.2.7. JTAG Programming Operation Issue
1.2. Arm* Cortex* -A9 MPCore* and L2 Cache Errata x
1.2.1. Arm* Cortex* -A9 MPU 1.2.2. Arm* L2 Cache Controller 1.2.3. Arm* CoreSight PTM
1.2.1. Arm* Cortex* -A9 MPU x
1.2.1.1. 761319: Ordering of Read Accesses to the Same Memory Location Might Be Uncertain 1.2.1.2. 775420: Particular Data Cache Maintenance Operation Which Aborts Might Lead to Deadlock 1.2.1.3. 782772: Speculative Execution of LDREX or STREX Instruction After a Write to Strongly Ordered Memory Might Lead to Deadlock 1.2.1.4. 761320: Full Cache Line Writes to the Same Memory Region From Both Processors Might Cause Deadlock 1.2.1.5. 845369: Under Very Rare Timing Circumstances Transition into Streaming Mode Might Create Data Corruption 1.2.1.6. 740657: Global Timer Can Send Two Interrupts for the Same Event 1.2.1.7. 751476: Missed Watchpoint on the Second Part of an Unaligned Access Crossing a Page Boundary 1.2.1.8. 754322: Faulty MMU Translations Following ASID Switch 1.2.1.9. 764369: Data or Unified Cache Line Maintenance by MVA Fails on Inner-Shareable Memory 1.2.1.10. 782773: Updating a Translation Entry to Move a Page Mapping Might Erroneously Cause an Unexpected Translation Fault 1.2.1.11. 794072: A Short Loop Including DMB Instruction Might Cause a Denial of Service When the Other Processor Executes a CP15 Broadcast Operation 1.2.1.12. 794073: Speculative Instruction Fetches with MMU Disabled Might Not Comply with Architectural Requirements 1.2.1.13. 794074: A Write Request to an Uncacheable, Shareable Normal Memory Region Might be Executed Twice, Possibly Causing a Software Synchronization Issue 1.2.1.14. 725631: ISB is Counted in Performance Monitor Events 0x0C and 0x0D 1.2.1.15. 729817: MainID Register Alias Addresses Are Not Mapped on Debug APB Interface 1.2.1.16. 729818: In Debug State, the Next Instruction is Stalled When the SDABORT Flag is Set Instead of Being Discarded 1.2.1.17. 751471: DBGPCSR Format Is Incorrect 1.2.1.18. 752519: An Imprecise Abort Might Be Reported Twice on Non-Cacheable Reads 1.2.1.19. 754323: Repeated Store in the Same Cache Line Might Delay the Visibility of the Store 1.2.1.20. 756421: Sticky Pipeline Advance Bit Cannot be Cleared from Debug APB Accesses 1.2.1.21. 757119: Some Unallocated Memory Hint Instructions Generate an UNDEFINED Exception Instead of Being Treated as a NOP 1.2.1.22. 761321: MRC and MCR Are Not Counted in Event 0x68 1.2.1.23. 764319: Read Accesses to DBGPRSR and DBGPRCR May Generate an Unexpected UNDEF 1.2.1.24. 771221: PLD Instructions Might Allocate Data in the Data Cache Regardless of the Cache Enable Bit Value 1.2.1.25. 771224: Visibility of Debug Enable Access Rights to Enable/Disable Tracking is Not Ensured by an ISB 1.2.1.26. 771225: Speculative Cacheable Reads to Aborting Memory Regions Clear the Internal Exclusive Monitor and May Lead to Livelock 1.2.1.27. 775419: PMU Event 0x0A Might Count Twice the LDM PC ^ Instruction with Base Address Register Write-Back 1.2.1.28. 782774: A Spurious Event 0x63 Can be Reported on an LDREX That is preceded by a Write to Strongly Ordered Memory Region
1.2.2. Arm* L2 Cache Controller x
1.2.2.1. 754670: A Continuous Write Flow Can Stall a Read Targeting the Same Memory Area 1.2.2.2. 765569: Prefetcher Can Cross 4 KB Boundary if Offset is Programmed with Value 23 1.2.2.3. 729815: The High Priority for SO and Dev Reads Feature Can Cause Quality of Service Issues to Cacheable Read Transactions Description Impact Workaround Category
1.2.3. Arm* CoreSight PTM x
1.2.3.1. 720107: Periodic Synchronization Can Be Delayed and Cause Overflow 1.2.3.2. 711668: Configuration Extension Register Has Wrong Value Status
1. Cyclone® V SX, ST and SE SoC Device Errata

1.2.2.3. 729815: The High Priority for SO and Dev Reads Feature Can Cause Quality of Service Issues to Cacheable Read Transactions

Description

The "High Priority for SO and Dev reads" feature can be enabled by setting bit[10] of the PL310 Auxiliary Control Register. When enabled, this feature gives priority to strongly ordered and device reads over cacheable reads in the PL310 AXI master interfaces. When PL310 receives a continuous flow of strongly ordered or device reads, this configuration can prevent cacheable reads that miss in the L2 cache from being issued to the L3 memory system.

This erratum occurs when the following conditions are met:

  • Bit[10] "High Priority for SO and Dev reads enable" of the PL310 Auxiliary Control Register is set to 1.
  • PL310 receives a cacheable read that misses in the L2 cache.
  • PL310 receives a continuous flow of strongly ordered or device reads that take all address slots in the master interface.

Impact

When the conditions above are met, the linefill resulting from the L2 cache miss is not issued until the flow of SO/Device reads stops. Note that each PL310 master interface has four address slots, so that the Quality of Service issue only appears on the cacheable read if the L1 is able to issue at least four outstanding SO/Device reads.

Workaround

A workaround is only necessary in systems that are able to issue a continuous flow of strongly ordered or device reads. In such a case, the workaround is to disable the "High Priority for SO and Dev reads" feature, which is the default behavior.

Category

Category 3

Level Two Title