Stratix® 10 Power Management User Guide

ID 683418
Date 10/29/2024
Public
Document Table of Contents

3.1.1.1. Configuration Pin Parameters

You can configure the following power management pins using the GUI parameters.

Table 10.  Configuration Pin Parameters
Parameters Value Description
Use PWRMGT_SCL output SDM_IO0

This is a required PMBus interface for the power management when the VID operation mode is the PMBus Master or PMBus Slave mode.

Disable this parameter for the non-SmartVID device.

Altera recommends using the SDM_IO14 pin for this parameter.

SDM_IO14
Use PWRMGT_SDA output SDM_IO11

This is a required PMBus interface for the power management when the VID operation mode is the PMBus Master or PMBus Slave mode.

Disable this parameter for the non-SmartVID device.

Altera recommends using the SDM_IO11 pin for this parameter.

SDM_IO12
SDM_IO16
Use PWRMGT_ALERT output SDM_IO0

This is a required PMBus interface for the power management that is used only in the PMBus Slave mode.

Disable this parameter for the non-SmartVID device.

Altera recommends using the SDM_IO12 pin for this parameter.

This parameter is an active-low signal.

SDM_IO9
SDM_IO12