F-Tile CPRI PHY Intel® FPGA IP User Guide

Download PDF
ID 683284
Date 8/15/2024
Public
Document Table of Contents
Document Table of Contents x
1. About the F-Tile CPRI PHY Intel® FPGA IP 2. Getting Started 3. IP Parameter Settings 4. Functional Description 5. IP Registers 6. F-Tile CPRI PHY Intel FPGA IP User Guide Archives 7. Document Revision History for the F-Tile CPRI PHY Intel FPGA IP User Guide
1. About the F-Tile CPRI PHY Intel® FPGA IP x
1.1. Supported Features 1.2. Block Diagram 1.3. Device Family Support 1.4. Device Speed Grade Support 1.5. Resource Utilization 1.6. F-Tile CPRI PHY IP Release Information
2. Getting Started x
2.1. Installing and Licensing Intel® FPGA IP Cores 2.2. Specifying the IP Core Parameters and Options 2.3. Generated File Structure 2.4. IP Core Testbenches
2.1. Installing and Licensing Intel® FPGA IP Cores x
2.1.1. Intel® FPGA IP Evaluation Mode
2.2. Specifying the IP Core Parameters and Options x
2.2.1. Reference and System PLL Clock for your IP Design
3. IP Parameter Settings x
3.1. Analog Parameters for F-Tile IPs
4. Functional Description x
4.1. Reset Logic 4.2. Latency Measurement
4.2. Latency Measurement x
4.2.1. Deterministic Latency 4.2.2. Calculation for 64b/66b Datapath
1. About the F-Tile CPRI PHY Intel® FPGA IP
2. Getting Started
3. IP Parameter Settings
4. Functional Description
5. IP Registers
6. F-Tile CPRI PHY Intel FPGA IP User Guide Archives
7. Document Revision History for the F-Tile CPRI PHY Intel FPGA IP User Guide

2.4. IP Core Testbenches

Intel provides a testbench and compilation-only design example that you can generate for the F-Tile CPRI PHY Intel® FPGA IP core.

To generate the testbench, in the F-Tile CPRI PHY Intel® FPGA IP parameter editor, you must first set the parameter values for the IP core variation you intend to generate in your end product. If you do not set the parameter values for your DUT to match the parameter values in your end product, the testbench you generate does not exercise the IP core variation you intend.

The testbench demonstrates XGMII data transfer to PHY with internal serial loopback and performs basic latency calculations. It is not intended to be a substitute for a full verification environment.
Note: A compilation-only design example provides reports of timing and resource utilization. It is not a hardware testing design example.
Related Information
Level Two Title