Visible to Intel only — GUID: mwh1416951964055
Ixiasoft
2.3.1. Recommended Initial SDC Constraints
2.3.2. SDC File Precedence
2.3.3. Iterative Constraint Modification
2.3.4. Creating Clocks and Clock Constraints
2.3.5. Creating I/O Constraints
2.3.6. Creating Delay and Skew Constraints
2.3.7. Creating Timing Exceptions
2.3.8. Example Circuit and SDC File
2.3.7.5.1. Default Multicycle Analysis
2.3.7.5.2. End Multicycle Setup = 2 and End Multicycle Hold = 0
2.3.7.5.3. End Multicycle Setup = 2 and End Multicycle Hold = 1
2.3.7.5.4. Same Frequency Clocks with Destination Clock Offset
2.3.7.5.5. Destination Clock Frequency is a Multiple of the Source Clock Frequency
2.3.7.5.6. Destination Clock Frequency is a Multiple of the Source Clock Frequency with an Offset
2.3.7.5.7. Source Clock Frequency is a Multiple of the Destination Clock Frequency
2.3.7.5.8. Source Clock Frequency is a Multiple of the Destination Clock Frequency with an Offset
Visible to Intel only — GUID: mwh1416951964055
Ixiasoft
2.3. Using Timing Constraints
The following section describes correct application of SDC timing constraints that guide Fitter placement and allow accurate timing analysis. You can create an .sdc file with a set of initial recommended constraints, and then iteratively modify those constraints as the design progresses.