Ethernet Design Example Components User Guide

Download PDF
ID 683044
Date 3/28/2022
Public

A newer version of this document is available. Customers should click here to go to the newest version.

Document Table of Contents
Document Table of Contents x
1. Time-of-day Clock 2. Time-of-day Synchronizer 3. Packet Classifier 4. Ethernet Design Example Components User Guide Archives 5. Document Revision History for the Ethernet Design Example Components User Guide
1. Time-of-day Clock x
1.1. Release Information 1.2. Resource Utilization 1.3. Configuring the TOD Clock 1.4. Using the TOD Clock 1.5. Interface Signals 1.6. Configuration Registers
1.1. Release Information x
1.1.1. Pulse Per Second Device Speed Grade Support
1.4. Using the TOD Clock x
1.4.1. Adjusting TOD Drift 1.4.2. Adjusting Offset, Jitter, and Wander 1.4.3. Correcting TOD Offset 1.4.4. IOPLL and TOD Setup for Pulse Per Second (Advanced Accuracy Mode)
1.4.4. IOPLL and TOD Setup for Pulse Per Second (Advanced Accuracy Mode) x
1.4.4.1. IOPLL and TOD Setup using Dynamic Phase Shift Interface 1.4.4.2. IOPLL and TOD Setup using IOPLL Reconfig IP
1.5. Interface Signals x
1.5.1. Avalon Memory-Mapped Signals 1.5.2. Time-of-day Signals 1.5.3. Pulse-Per-Second Signals 1.5.4. Clocking Requirements
2. Time-of-day Synchronizer x
2.1. Release Information 2.2. Resource Utilization 2.3. Configuring the TOD Synchronizer 2.4. Using the TOD Synchronizer 2.5. Interface Signals
2.4. Using the TOD Synchronizer x
2.4.1. Sampling Clock Frequency
3. Packet Classifier x
3.1. Release Information 3.2. Resource Utilization 3.3. Configuring the Packet Classifier 3.4. Interface Signals
3.4. Interface Signals x
3.4.1. Clock and Reset Signals 3.4.2. Avalon® Streaming Interface Signals 3.4.3. Control Signals
1. Time-of-day Clock
2. Time-of-day Synchronizer
3. Packet Classifier
4. Ethernet Design Example Components User Guide Archives
5. Document Revision History for the Ethernet Design Example Components User Guide

1.4.4. IOPLL and TOD Setup for Pulse Per Second (Advanced Accuracy Mode)

There are two ways to set up IOPLL and TOD to enable advanced accuracy mode for pulse per second:
  • Using IOPLL dynamic phase shift interface.
    Note: Some devices do not support this setup.
  • Using IOPLL with IOPLL Reconfig IP.

Section Content
IOPLL and TOD Setup using Dynamic Phase Shift Interface
IOPLL and TOD Setup using IOPLL Reconfig IP

Level Two Title