2.2. Design Example Interface Signals
The 50GbE testbench is self-contained and does not require you to drive any input signals.
Signal | Direction | Comments |
---|---|---|
clk50 | Input | Drive at 50 MHz. The intent is to drive this from a 50 Mhz oscillator on the board. |
clk_ref | Input | Drive at 644.53125 MHz. |
cpu_resetn | Input | Resets the IP core. Active low. Drives the global hard reset csr_reset_n to the IP core. |
tx_serial[1:0] | Output | Transceiver PHY output serial data. |
rx_serial[1:0] | Input | Transceiver PHY input serial data. |
user_led[7:0] | Output | Status signals. The hardware design example connects these bits to drive LEDs on the target board. Individual bits reflect the following signal values and clock behavior:
|