DisplayPort Intel® FPGA IP User Guide

ID 683273
Date 4/29/2022
Public

A newer version of this document is available. Customers should click here to go to the newest version.

Document Table of Contents

5.8.5. Transceiver Reconfiguration Interface

You can reconfigure the transceiver to accept single reference clock. The single reference clock is a 135 MHz clock for all DP1.4 bit rates: RBR, HBR, HBR2, and HBR3. DP2.0 uses the reference clock at 100MHz for the UHBR10 data rate.

During run-time, you can reconfigure the transceiver to operate in either one of the bit rates by changing TX PLL divide ratio.

When the IP makes a request, the tx_reconfig_req port goes high. The user logic asserts tx_reconfig_ack and then reconfigures the transceiver. During reconfiguration, the user logic holds tx_reconfig_busy high. The user logic drives it low when reconfiguration completes.

Note: The transceiver requires a reconfiguration controller. Reset the transceiver to a default state upon power-up.