Intel® FPGA Programmable Acceleration Card N3000 Data Sheet

Download PDF
ID 683260
Date 6/30/2021
Public
Document Table of Contents
Document Table of Contents x
1. Introduction 2. Overview 3. System Compatibility 4. Mechanical Information 5. Thermal Specifications 6. Intel® Provided FPGA Image A. References B. Safety and Regulatory Information C. Document Revision History for Intel® FPGA Programmable Acceleration Card N3000 Data Sheet
2. Overview x
2.1. Intel® FPGA PAC N3000 Block Diagram 2.2. Overview of Product Features 2.3. PCIe Overview 2.4. Board Management Controller Overview
2.2. Overview of Product Features x
2.2.1. Intel® Arria® 10 GT FPGA 2.2.2. Intel® Ethernet Controller XL710-BM2 Network Interface Controller 2.2.3. On-Board Memory 2.2.4. Software and Firmware 2.2.5. Power 2.2.6. Network Interface
2.2.6. Network Interface x
2.2.6.1. Intel® Ethernet Connection C827 Retimer
2.4. Board Management Controller Overview x
2.4.1. Field Replaceable Unit Identification (FRUID) EEPROM
5. Thermal Specifications x
5.1. Cooling Requirements
B. Safety and Regulatory Information x
B.1. Regulatory Compliance
1. Introduction
2. Overview
3. System Compatibility
4. Mechanical Information
5. Thermal Specifications
6. Intel® Provided FPGA Image
A. References
B. Safety and Regulatory Information
C. Document Revision History for Intel® FPGA Programmable Acceleration Card N3000 Data Sheet

2.2.5. Power

The Intel® FPGA PAC N3000 source power must be provided from both the 12 V PCIe* slot and the 12 V Auxiliary 2×3 power connector. The Intel FPGA PAC does not power up if either power source is disconnected. The PCIe* specifications define the 12 V Auxiliary power connector pin assignment.

The Intel® FPGA PAC N3000 follows PCIe* standards for 150 W add-in cards where maximum current from the 12 V slot power source is 5.5 A (max) and the 12 V Auxilary connector is 6.25 A (max). As a developer or solution provider, you must design and operate the FPGA workload within these power guides. If the FPGA workload exceeds the limits provided by the server vendor, server safeguards may shut down the Intel® FPGA PAC N3000. Your FPGA workload must operate within the thermal specifications defined in this data sheet. The Intel® FPGA PAC N3000 is equipped with thermal protection circuitry that turns off board power if the FPGA junction temperature reaches 100 °C.

Note: The Intel® FPGA PAC N3000 does not support Wake-On LAN (WOL).
The figure below shows the pin-out for the PCIe 150W-ATX power connector.
Figure 3. Auxiliary Power Connector
  • Manufacturer: LOTES
  • Part Number: APOW0001-P001C01
  • Plating Finish:
    • 1:50u"MIN NICKEL UNDERPLATING 100U"
    • MIN MATTE TIN PLATING OVER ALL
Table 2.  Auxiliary Power Connector Pin-out Table
Pin Signal
1 +12 V
2 +12 V
3 +12 V
4 Ground
5 Sense
6 Ground
Level Two Title