Visible to Intel only — GUID: GUID-D518DD8C-3E32-440C-A14F-E1C92434FE5D
Visible to Intel only — GUID: GUID-D518DD8C-3E32-440C-A14F-E1C92434FE5D
AES-CCM Functions
This section describes functions for authenticated encryption/decryption using the Counter with Cipher Block Chaining-Message Authentication Code (CCM) mode NIST SP 800-38C of the AES (Rijndael128) block cipher.
The AES-CCM functions enable authenticated encryption/decryption of several messages using one key that the AES_CCMInit function sets. Processing of each new message starts with a call to the AES_CCMStart function. The application code for conducting a typical AES-CCM authenticated encryption should follow the sequence of operations as outlined below:
Get the size required to configure the context IppsAES_CCMState by calling the function AES_CCMGetSize.
Call the system memory-allocation service function to allocate a buffer whose size is not less than the function AES_CCMGetSize specifies.
Initialize the context IppsAES_CCMState*pCtx by calling the function AES_CCMInit with the allocated buffer and respective AES key.
Optionally call AES_CCMMessageLen and/or AES_CCMTagLen to set up message and tag parameters.
Call AES_CCMStart to start authenticated encryption of the first/next message.
Keep calling AES_CCMEncrypt until the entire message is processed.
Request the authentication tag by calling AES_CCMGetTag.
Proceed to the next message, if any, that is, go to step 5.
Clean up secret data stored in the context.
Call the system memory free service function to release the buffer allocated for the context IppsAES_CCMState, if needed.
Related Information