P-Tile Avalon® Streaming Intel® FPGA IP for PCI Express* User Guide

ID 683059
Date 9/26/2022
Public

A newer version of this document is available. Customers should click here to go to the newest version.

Document Table of Contents

3.3.3. User Avalon® -MM Interface

For more details on the signals in this interface, refer to the section Hard IP Reconfiguration Interface.

The majority of the PCIe standard registers are implemented in the user’s logic outside of the P-Tile Avalon® -ST IP.

However, the following registers still remain inside the P-Tile:
  • Power management capability
  • PCI Express capability
  • Secondary PCI Express capability
  • Data link feature extended capability
  • Physical layer 16.0GT/s extended capability
  • Lane margining at the receiver extended capability
  • Advanced error reporting capability

The application can only access PCIe controller registers through the User Avalon® -MM interface.

Table 43.  Capability Registers to be Updated by the Application Logic via the User Avalon-MM Interface
Capability Comments
Power Management Capability Need to write back since it is required to trigger a PCI-PM entry.
PCI Express Capability All the PCIe capabilities, control and status registers are for configuring the device. Write-back is required.
Secondary PCI Express Capability Secondary PCIe Capability is required for configuring the device.
Data Link Feature Extended Capability Data Link Capability is device specific.
Physical Layer 16.0 GT/s Extended Capability Physical Layer 16G Capability is device specific.
Lane Margining at the Receiver Extended Capability Margining Extended Capability is device specific.
Advanced Error Reporting Capability Write-back to error status registers is required for TLP Bypass.
Note: Refer to PCIe Configuration Space Registers for x16/x8/x4 Controllers for the address offsets information for the capability registers listed in the table above.
There are two options to implement the Device ID and Vendor ID of the PCIe Configuration Header Registers.
  1. Specify the Device ID and Vendor ID in the IP Parameter Editor and then read them from the PCIe Controller through the User Avalon-MM interface.
  2. Implement the Device ID and Vendor ID in the user logic.

The remaining registers of the PCIe Configuration Header Registers need to be implemented in the user logic.