Issue 70426: Chapter 13 “Configuring Cyclone II Devices " version 3.1
Table 13–3: Cyclone II Raw Binary File (.rbf) Sizes has incorrect.rbf sizes for the EP2C35 and EP2C50 devices. The correct .rbf sizes are as follow:
1. EP2C35 is 6,848,608 bits
2. EP2C50 is 9,951,104 bits
Issue 132933: Chapter 13 " Configuring Cyclone II Devices " version 3.1
There is Table 13–11. Dedicated Configuration Pins on the Cyclone II Device. The table incorrectly states "When using EPC2 devices, you should only use external 10-k. pull-up resistors." in the descriptions for nSTATUS and CONF_DONE. This sentence is for EPC1, not for EPC2. This sentence should say "When using EPC1 devices, you should only use external 10-k. pull-up resistors."
Resolved Issues
Issue 1-5HG00E, Chapter 7 "PLLs in Cyclone II Devices", Version 2.0
Figure 7-16 in version 2.0 was corrected in version 2.1 (and re-named Figure 7-17) to show the Cyclone® II device VCCA pins are powered by 1.2V.