Interface
settings— Allow you to view and specify
applicable parameters for each interface as follows:
Name—
Specifies a unique name for your interface.
Type—
Specifies the interface type.
Associated
Clock— Specifies a clock signal for the
interface.
Associated
Reset— Specifies a reset signal for the
interface.
Block
Diagram— Displays a block diagram
containing signals associated with the interface on the
Signals tab.
Parameters—
Specifies general parameters for the interface.
Timing— Specifies
the timing parameters for the interface.
Pipelined
Transfers— Specifies the parameters for
pipelined transfers.
Waveforms— Displays
waveform diagrams associated with the interface, including read,
write, and packet transfer waveforms.
Add Interface— Specifies a new interface. By
default, the type of interface added is a memory-mapped agent interface. After
adding, use Type to change the interface
type.
Remove Interfaces With No
Signals— Deletes all interfaces displayed
on the Interfaces tab that
have no signals associated with them.