In-System Sources and Probes Instance Manager Pane (In-System Sources and Probes Editor) You open this pane in the In-System Sources and Probes Editor by clicking View > Instance Manager. Select JTAG Debugging Information File Dialog Box You open this dialog box by clicking Recreate Instances From JTAG Debugging Information File on the Edit menu. Set Alias/Delete Alias Commands (Edit Menu) You can access these commands by clicking Set Alias or Delete Alias on the Edit menu. These commands are available only when the In-System Sources and Probes Editor window is open. Bus Bit Order Commands (Edit Menu) You can access these commands by pointing to Bus Bit Order on the Edit menu, and then clicking MSB on Top, LSB on Bottom or LSB on Top, MSB on Bottom. These commands are available only when the In-System Sources and Probes Editor window is open. Bus Display Format Commands (Edit Menu) You can access these commands by pointing to Bus Display Format on the Edit menu, and then clicking one of the format commands. These commands are available only when the In-System Sources and Probes Editor window is open. Recreate Instances Commands (Edit Menu) You can access these commands by clicking Recreate Instances From JTAG Debugging Information File or Recreate Instances From JTAG Device on the Edit menu. These commands are available only when the In-System Sources and Probes Editor window is open. Set Value of Source Commands (Edit Menu) You can access these commands by pointing to Set Value of Source on the Edit menu, and then clicking High or Low. These commands are available only when the In-System Sources and Probes Editor window is open. JTAG Chain Configuration Pane (In-System Sources and Probes Editor) You open this pane in the In-System Sources and Probes Editor by clicking View > JTAG Chain Configuration. Read Probe Data Commands (Processing Menu) You can access these commands by clicking them on the Processing menu. These commands are available only when the In-System Sources and Probes Editor window is open. Source Data Commands (Processing Menu) You can access these commands by clicking Write Source Data or Read Source Data on the Processing menu. These commands are available only when the In-System Sources and Probes Editor is open.