NSS-30018: Design Contains Delay Chains

Delay chains are one or more consecutive nodes that act as a buffer for creating intentional delay. The following images are examples of delay chains:

Figure 1. Delay Chain Examples



Delay chains often result from asynchronous design practices and can cause problems, including an increase in a design's sensitivity to operating conditions, and a decrease in a design's reliability. In addition, for all Intel devices supported by the Intel® Quartus® Prime Pro Edition software, using a delay chain is unnecessary in purely synchronous circuits that use dedicated clocks.

This rule checks for delay chains implemented in the logic cell only. Delay chains in I/O portions of the device are not detected by the Design Assistant.

Important:
  • Messages for this rule can occur when a design contains pre-built Intel FPGA IP with parameter settings that cause an EDA synthesis tool to not remove all unused logic elements from the design during synthesis. When Intel FPGA IP functions are the cause of violations, the design is still synchronous and the unused logic elements do not cause problems in the design.
  • Messages are also reported in circumstances where a delay chain exists on the clock or reset path, but not when a delay chain is used on the data path.

Recommendation

Do not include delay chains in your design.

Severity

High

Stage

Analysis and Elaboration

Device Family

  • Intel® Arria® 10
  • Intel® Cyclone® 10 GX