DQ I/O Definition

The DQ I/O pins in supported device ( Arria^® series, and Stratix^® series) family devices send and receive data signals in a bidirectional bus. Data pins in the bus are labeled DQ and the strobe pin is labeled DQS.

The DQ I/O pins in Cyclone^® series family devices are normal bidirectional pins placed for optimal timing near associated DQS I/O pins. Data is latched using double data rate (DDR) circuitry in a Cyclone^® series device. Data pins in the DDR circuitry are labeled DQ and the strobe pin is labeled DQS.

RAM that use DDR are designed to transfer two data words per clock cycle, using both the positive and the negative edge of the clock. With each word of data, a data-strobe (clock) is transferred for synchronization. Typically, for each 8 bits of data (DQ[7..0]), a single DQS signal is needed.

DQ I/O data signals act as inputs to the device when the device is reading from a RAM that uses DDR, and outputs when the device is writing to a RAM that uses DDR.

In input mode (reading from the RAM), the device receives the DQ signals edge-aligned with the DQS strobe. To maximize setup and hold constraints, the clock (DQS) is delayed internally using a delay locked loop that shifts the data 90 degrees with respect to the system clock. The data is latched using the DDIO circuitry.

In output mode (writing to the RAM), the device sends the DQ signals center-aligned (90 degrees) out of phase with the DQS signal. This is done by generating a clock using the DDIO circuitry in the PLD and shifting the output clock of the data by 90 degrees using PLLs.