Parameters
Parameter |
Type |
Required |
Comments |
---|---|---|---|
|
String |
Yes |
Specifies the DLL phase shift. Values are
|
|
String |
Values are |
|
|
String |
No |
Specifies whether the |
|
String |
No |
Specifies the power-up condition of the oe
registers. Values are |
|
String |
No |
Specifies whether the |
|
String |
No |
Specifies whether |
|
String |
No |
Specifies whether to use the open drain mode.
Values are |
|
String |
No |
Specifies whether the |
|
String |
No |
Specifies the power-up condition of the DQS
output registers. Values are |
|
String |
No |
Specifies whether the |
|
String |
No |
Specifies whether to use the second
|
|
String |
No |
Specifies the frequency of the DQS inputs and system reference clock. |
|
Integer |
Yes |
Specifies the number of DQS pins that are implemented. |
|
Integer |
No |
Specifies the number of DQS Controls. The
default value is |
|
Integer |
No |
Specifies the number of half-cycles that the
DLL keeps locked after a bad clock is detected. The default is
|
|
Integer |
No |
Specifies the number of half-cycles required
before the DLL locks onto the signal. The default value is
|
|
String |
No |
Specifies whether the clock enable for the
output registers are tied-off (does not affect the output
registers). Values are |
|
String |
No |
Specifies whether the clock enable for the oe
registers that are controlled by the |
|
String |
No |
Specifies the value of the delay requirement.
The |
|
String |
No |
Specifies whether to use a delay requirement.
Values are |