Trigger in

Allows you to enable the trigger input signal for the selected instance, and to specify a logic condition in the Pattern list to synchronize the trigger process to a signal from outside the programmable logic device (PLD). The trigger input signal can be a device Pin, Node from the design, signal in a different Instance in the design, or Hard Processor System (HPS) trigger out. You must use an unused input pin to connect the external signal to the SignalTap II Logic Analyzer trigger input signal. Only one trigger input signal type is accepted.

This option is configurable at runtime.

In the Pattern list, you can set the specified trigger input pin to recognize any of the following logic conditions:

text-align:left;

	Logic Condition	Node Condition Required for Trigger to Occur
	Don't care	Doesn't matter
	High	High
	Low	Low
	Falling Edge	Falling
	Rising Edge	Rising
	Either Edge	Rising or falling