Interfaces Pane

Interface settings— Allow you to view and specify applicable parameters for each interface as follows:

Name— Specifies a unique name for your interface.

Type— Specifies the interface type.

Associated Clock— Specifies a clock signal for the interface.

Associated Reset— Specifies a reset signal for the interface.

Block Diagram— Displays a block diagram containing signals associated with the interface on the Signals tab.

Parameters— Specifies general parameters for the interface.

Timing— Specifies the timing parameters for the interface.

Pipelined Transfers— Specifies the parameters for pipelined transfers.

Waveforms— Displays waveform diagrams associated with the interface, including read, write, and packet transfer waveforms.

Add Interface— Specifies a new interface. By default, the type of interface added is a memory-mapped slave interface. After adding, use Type to change the interface type.

Remove Interfaces With No Signals— Deletes all interfaces displayed on the Interfaces tab that have no signals associated with them.