The ALT_OUTBUF_TRI primitive allows you to do the
following:
- Make a location assignment
- Make an I/O standards Definition
assignment
- Make a drive strength (current strength) assignment
- Enable bus-hold circuitry
- Enable a weak pull-up resistor
- Make slow slew rate assignments
- Make an on-chip termination (OCT) assignment to an output pin
from a lower-level entity
This primitive is available for supported
device(CycloneIII, MAXII, and
StratixIII) families.
Note: - Trying to set other parameters not listed in
the Parameters table on the ALT_OUTBUF_TRI primitive results in errors.
- For information about Quartus® Prime Standard Edition primitive
instantiation, go to Using a Quartus® Prime Standard Edition Logic
Function.