The ALT_INBUF_DIFF primitive allows you to name and
connect positive and negative pins when a differential I/O standards Definition is applied
to an input pin. This primitive allows you to do the following:
- Make a location assignment
- Make an I/O standard assignment
- Enable bus-hold circuitry
- Enable a weak pull-up resistor
- Make an on-chip termination (OCT) assignment to an input pin
from a lower-level entity
This primitive is available for CycloneIII and
StratixIII devices only.
Note: - Trying to set other parameters not listed in
the Parameters table on the ALT_INBUF_DIFF primitive results in errors.
- For information about Quartus® Prime Standard Edition primitive
instantiation, go to Using a Quartus® Prime Standard Edition Logic
Function.