EMMC_DDR_REG
Name: EMMC DDR Register
Size: 32 bits
Address Offset: 0x10C
Read/Write access: read/write
| Module Instance | Base Address | Register Address |
|---|---|---|
| sdm_i_sdmmc_sdmmc_block | 0xFF8D1000 | 0xFF8D110C |
Size: 32
Offset: 0x10C
Access: RW
Important: The value of a reserved bit must be maintained in software. When you modify registers containing reserved bit fields, you must use a read-modify-write operation to preserve state and prevent indeterminate system behavior.
| Bit Fields | |||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
| 31 | 30 | 29 | 28 | 27 | 26 | 25 | 24 | 23 | 22 | 21 | 20 | 19 | 18 | 17 | 16 |
|
HS400_MODE RO 0x0 |
Reserved |
||||||||||||||
| 15 | 14 | 13 | 12 | 11 | 10 | 9 | 8 | 7 | 6 | 5 | 4 | 3 | 2 | 1 | 0 |
|
Reserved |
HALF_START_BIT_0 RW 0x0 |
||||||||||||||
EMMC_DDR_REG Fields
| Bit | Name | Description | Access | Reset | ||||||
|---|---|---|---|---|---|---|---|---|---|---|
| 31 | HS400_MODE |
HS400 Mode Enable
■ 1'b0 - Disable
■ 1'b1 - Enable
Note: The application is required to set this bit to '1' before initiating any data
transfer CMD in HS400 mode. This bit shall be cleared by the host on exiting HS400 mode.
In non HS400 mode, this bit shall be set to '0'
|
RO | 0x0 | ||||||
| 0 | HALF_START_BIT_0 |
Control for start bit detection mechanism inside
DWC_mobile_storage based on duration of start bit; each bit refers to one slot. For eMMC 4.5, start bit can
be:
■ Full cycle (HALF_START_BIT = 0)
■ Less than one full cycle (HALF_START_BIT = 1)
Set HALF_START_BIT=1 for eMMC 4.5 and above; set to 0 for SD applications.
Note: This bit is not applicable for HS400 mode
|
RW | 0x0 |