brgmodrst 

         The BRGMODRST register is used by software to control the bridge module resets. Software explicitly asserts and de-asserts module reset signals by writing bits in the appropriate *MODRST register. It is up to software to ensure module reset signals are asserted for the appropriate length of time and are de-asserted in the correct order. It is also up to software to not assert a module reset signal that would prevent software from de-asserting the module reset signal.  
Software writes a bit to 1 to assert the module reset signal and to 0 to de-assert the module reset signal.
All fields are reset by a cold reset. All fields are also reset by a warm reset if not masked by the corresponding BRGWARMMASK field.
The reset value of all fields is 1. This holds the corresponding module in reset until software is ready to release the module from reset by writing 0 to its field.
Module Instance Base Address Register Address
i_rst_mgr_rstmgr 0xFFD11000 0xFFD1102C

Size: 32

Offset: 0x2C

Access: RW

Access mode: PRIVILEGEMODE

Note: The processor must make a privileged bus access to this register. You can configure processor mode settings in the control registers of the ARM Cortex-A53 MPcore processor. For more information about processor modes, please refer to the ARM Infocenter.

Important: The value of a reserved bit must be maintained in software. When you modify registers containing reserved bit fields, you must use a read-modify-write operation to preserve state and prevent indeterminate system behavior.
Bit Fields
31 30 29 28 27 26 25 24 23 22 21 20 19 18 17 16

Reserved

15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0

Reserved

ddrsch

RW 0x1

f2ssdram2

RW 0x1

f2ssdram1

RW 0x1

f2ssdram0

RW 0x1

fpga2soc

RW 0x1

lwhps2fpga

RW 0x1

soc2fpga

RW 0x1

brgmodrst Fields

Bit Name Description Access Reset
6 ddrsch 
Resets logic in the DDR Scheduler in the NOC.
 RW 0x1
5 f2ssdram2 
Resets F2S_SDRAM2 Bridge.
 RW 0x1
4 f2ssdram1 
Resets F2S_SDRAM1 Bridge.
 RW 0x1
3 f2ssdram0 
Resets F2S_SDRAM0 Bridge.
 RW 0x1
2 fpga2soc 
Resets FPGA2SOC Bridge.
NOTE: Software must never write a 0x1 to this bit.  Software may only write a 0x0 to this bit.
 RW 0x1
1 lwhps2fpga 
Resets LWHPS2FPGA Bridge.
 RW 0x1
0 soc2fpga 
Resets SOC2FPGA Bridge.
 RW 0x1