STET

         Shadow TX Empty Trigger

Module Instance	Base Address	Register Address
`i_uart_uart_address_block`	`0xFF8D0000`	`0xFF8D00A0`

Size: 32

Offset: 0xA0

Access: RW

Important: The value of a reserved bit must be maintained in software. When you modify registers containing reserved bit fields, you must use a read-modify-write operation to preserve state and prevent indeterminate system behavior.

Bit Fields
31	30	29	28	27	26	25	24	23	22	21	20	19	18	17	16
`RSVD_STET_31to2` `RO 0x0`
15	14	13	12	11	10	9	8	7	6	5	4	3	2	1	0
`RSVD_STET_31to2` `RO 0x0`														`stet` `RW 0x0`

STET Fields

Bit

Name

Description

Access

Reset

31:2

RSVD_STET_31to2

Reserved bits [31:2] - Read Only

RO

0x0

1:0

stet

Shadow TX Empty Trigger.
This is a shadow register for the TX empty trigger bits (FCR[5:4]). This can be used
to remove the burden of having to store the previously written value to the FCR in
memory and having to mask this value so that only the TX empty trigger bit gets updated.
Writes will have no effect when THRE_MODE_USER == Disabled. This is used to select the
empty threshold level at which the THRE Interrupts will be generated when the mode is
active. These threshold levels are also described in. The following trigger levels are
supported:
00 = FIFO empty
01 = 2 characters in the FIFO
10 = FIFO 1/4 full
11 = FIFO 1/2 full

Value	Description
0x0	FIFO empty
0x1	2 characters in FIFO
0x2	FIFO 1/4 full
0x3	FIFO 1/2 full

RW

0x0