bridge_fpga0ace_mprt_1_118_am_err
These error status bits record the first error event and have to be cleared by writing a 1'b0 before new errors are recorded. e0 - e7 are relative to AR channel. e16 - e23 are WR channel counter parts.
Module Instance | Base Address | Register Address |
---|---|---|
i_ccu_noc_registers | 0xF7000000 | 0xF700FE00 |
Size: 64
Offset: 0xFE00
Access: RW
Access mode: SECURE | PRIVILEGEMODE
Note: The processor must make a secure, privileged bus access to this register. You can configure processor mode settings in the control registers of the ARM Cortex-A53 MPcore processor. For more information about processor modes, please refer to the ARM Infocenter.
Bit Fields | |||||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
63 | 62 | 61 | 60 | 59 | 58 | 57 | 56 | 55 | 54 | 53 | 52 | 51 | 50 | 49 | 48 |
UNSD_63_41 RO 0x0 |
|||||||||||||||
47 | 46 | 45 | 44 | 43 | 42 | 41 | 40 | 39 | 38 | 37 | 36 | 35 | 34 | 33 | 32 |
UNSD_63_41 RO 0x0 |
E40 RW 0x0 |
UNSD_39_35 RO 0x0 |
E34 RW 0x0 |
E33 RW 0x0 |
E32 RW 0x0 |
||||||||||
31 | 30 | 29 | 28 | 27 | 26 | 25 | 24 | 23 | 22 | 21 | 20 | 19 | 18 | 17 | 16 |
UNSD_31_25 RO 0x0 |
E24 RW 0x0 |
E23 RW 0x0 |
E22 RW 0x0 |
E21 RW 0x0 |
E20 RW 0x0 |
E19 RW 0x0 |
E18 RW 0x0 |
E17 RW 0x0 |
E16 RW 0x0 |
||||||
15 | 14 | 13 | 12 | 11 | 10 | 9 | 8 | 7 | 6 | 5 | 4 | 3 | 2 | 1 | 0 |
UNSD_15_9 RO 0x0 |
E8 RW 0x0 |
E7 RW 0x0 |
E6 RW 0x0 |
E5 RW 0x0 |
E4 RW 0x0 |
E3 RW 0x0 |
E2 RW 0x0 |
E1 RW 0x0 |
E0 RW 0x0 |
bridge_fpga0ace_mprt_1_118_am_err Fields
Bit | Name | Description | Access | Reset |
---|---|---|---|---|
63:41 | UNSD_63_41 |
|
RO | 0x0 |
40 | E40 |
1'b1: Indicates that portcheck detected error (SIB mode only) |
RW | 0x0 |
39:35 | UNSD_39_35 |
|
RO | 0x0 |
34 | E34 |
1'b1: Traffic sent to a noc layer which is power gate |
RW | 0x0 |
33 | E33 |
1'b1: Capture counter1 overflow |
RW | 0x0 |
32 | E32 |
1'b1: Capture counter0 overflow |
RW | 0x0 |
31:25 | UNSD_31_25 |
|
RO | 0x0 |
24 | E24 |
1'b1: Unexpected narrow write detected |
RW | 0x0 |
23 | E23 |
1'b1: Write WRAP not equal to supported cacheline size |
RW | 0x0 |
22 | E22 |
1'b1: Write respone timeout |
RW | 0x0 |
21 | E21 |
1'b1: Write address multi-hit |
RW | 0x0 |
20 | E20 |
1'b1: Write exclusive split |
RW | 0x0 |
19 | E19 |
1'b1: Non modifiable WRAP |
RW | 0x0 |
18 | E18 |
1'b1: Write slave error |
RW | 0x0 |
17 | E17 |
1'b1: Write address decode error from slave |
RW | 0x0 |
16 | E16 |
1'b1: Local write address decode error |
RW | 0x0 |
15:9 | UNSD_15_9 |
|
RO | 0x0 |
8 | E8 |
1'b1: Unexpected narrow read detected |
RW | 0x0 |
7 | E7 |
1'b1: Read WRAP not equal to supported cacheline size: A WRAP command of unupported cache line size was detected |
RW | 0x0 |
6 | E6 |
1'b1: Read response timeout: Read response timeout occurred. With timeout enabled, a response wasn't received within the expected interval |
RW | 0x0 |
5 | E5 |
1'b1: Read address multi-hit: An AR command matched against multiple entries in the address table |
RW | 0x0 |
4 | E4 |
1'b1: Read exclusive split: An AR command of FIXED burst type was detected |
RW | 0x0 |
3 | E3 |
1'b1: Non modifiable WRAP: A WRAP command marked as non-modifiable (ARCACHE[0]=0) was detected |
RW | 0x0 |
2 | E2 |
1'b1: Read slave error: A slave error response was received from a slave device |
RW | 0x0 |
1 | E1 |
1'b1: Read address decode error from slave: A decode error response was received from a slave device |
RW | 0x0 |
0 | E0 |
1'b1: Local read address decode error: ARADDR did not find a match in the master bridges address table and a decode error was issued |
RW | 0x0 |