pinmux_dedicated_io_16

         This register is used to control the peripherals connected to dedicated IO pin 16
Only reset by a cold reset (ignores warm reset).
NOTE: These registers should not be modified after IO configuration.There is no support for dynamically changing the Pin Mux selections.
Module Instance Base Address Register Address
i_io48_pin_mux_dedicated_io_grp 0xFFD07200 0xFFD0723C

Offset: 0x3C

Access: RW

Important: The value of a reserved bit must be maintained in software. When you modify registers containing reserved bit fields, you must use a read-modify-write operation to preserve state and prevent indeterminate system behavior.
Bit Fields
31 30 29 28 27 26 25 24 23 22 21 20 19 18 17 16

Reserved
15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0

Reserved

sel

RW 0xF

pinmux_dedicated_io_16 Fields

Bit Name Description Access Reset
31:4 Reserved 
Reserved
 RO 0x0
3:0 sel 
Select peripheral signals connected Dedicated IO 16
0000 (0) Pin is connected to Peripheral signal i2c_emac0.sda
0001 (1) Pin is connected to Peripheral signal emac0.mdio
0010 (2) Pin is connected to Peripheral signal spis0.mosi
0011 (3) Pin is connected to Peripheral signal not applicable
0100 (4) Pin is connected to Peripheral signal not applicable
0101 (5) Pin is connected to Peripheral signal not applicable
0110 (6) Pin is connected to Peripheral signal not applicable
0111 (7) Pin is connected to Peripheral signal not applicable
1000 (8) Pin is connected to Peripheral signal qspi.ss2
1001 (9) Pin is connected to Peripheral signal not applicable
1010 (10) Pin is connected to Peripheral signal not applicable
1011 (11) Pin is connected to Peripheral signal not applicable
1100 (12) Pin is connected to Peripheral signal not applicable
1101 (13) Pin is connected to Peripheral signal uart1.tx
1110 (14) Pin is connected to Peripheral signal nand.adq6
1111 (15) Pin is connected to Peripheral signal gpio2.io12
 RW 0xF