pinmux_shared_io_q3_4

         This register is used to control the peripherals connected to shared IO48 pin Q3 4
Only reset by a cold reset (ignores warm reset).
NOTE: These registers should not be modified after IO configuration.There is no support for dynamically changing the Pin Mux selections.
      
Module Instance Base Address Register Address
i_io48_pin_mux_shared_3v_io_grp 0xFFD07000 0xFFD0706C

Offset: 0x6C

Access: RW

Important: The value of a reserved bit must be maintained in software. When you modify registers containing reserved bit fields, you must use a read-modify-write operation to preserve state and prevent indeterminate system behavior.
Bit Fields
31 30 29 28 27 26 25 24 23 22 21 20 19 18 17 16

Reserved

15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0

Reserved

sel

RW 0xF

pinmux_shared_io_q3_4 Fields

Bit Name Description Access Reset
31:4 Reserved
Reserved
RO 0x0
3:0 sel
Select peripheral signals connected shared IO48 Q3 4
0000 (0) Pin is connected to Peripheral signal i2c0.scl
0001 (1) Pin is connected to Peripheral signal not applicable
0010 (2) Pin is connected to Peripheral signal not applicable
0011 (3) Pin is connected to Peripheral signal spim1.ss0_n
0100 (4) Pin is connected to Peripheral signal not applicable
0101 (5) Pin is connected to Peripheral signal not applicable
0110 (6) Pin is connected to Peripheral signal not applicable
0111 (7) Pin is connected to Peripheral signal not applicable
1000 (8) Pin is connected to Peripheral signal emac1.rx_ctl
1001 (9) Pin is connected to Peripheral signal not applicable
1010 (10) Pin is connected to Peripheral signal not applicable
1011 (11) Pin is connected to Peripheral signal not applicable
1100 (12) Pin is connected to Peripheral signal not applicable
1101 (13) Pin is connected to Peripheral signal uart0.rx
1110 (14) Pin is connected to Peripheral signal nand.re_n
1111 (15) Pin is connected to Peripheral signal gpio1.io3
RW 0xF