pinmux_shared_io_q1_7

         This register is used to control the peripherals connected to shared IO48 pin Q1 7
Only reset by a cold reset (ignores warm reset).
NOTE: These registers should not be modified after IO configuration.There is no support for dynamically changing the Pin Mux selections.
Module Instance Base Address Register Address
i_io48_pin_mux_shared_3v_io_grp 0xFFD07000 0xFFD07018

Offset: 0x18

Access: RW

Important: The value of a reserved bit must be maintained in software. When you modify registers containing reserved bit fields, you must use a read-modify-write operation to preserve state and prevent indeterminate system behavior.
Bit Fields
31 30 29 28 27 26 25 24 23 22 21 20 19 18 17 16

Reserved
15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0

Reserved

sel

RW 0xF

pinmux_shared_io_q1_7 Fields

Bit Name Description Access Reset
31:4 Reserved 
Reserved
 RO 0x0
3:0 sel 
Select peripheral signals connected shared IO48 Q1 7
0000 (0) Pin is connected to Peripheral signal i2c_emac2.sda
0001 (1) Pin is connected to Peripheral signal emac2.mdio
0010 (2) Pin is connected to Peripheral signal not applicable
0011 (3) Pin is connected to Peripheral signal spim0.miso
0100 (4) Pin is connected to Peripheral signal sdmmc.data4
0101 (5) Pin is connected to Peripheral signal not applicable
0110 (6) Pin is connected to Peripheral signal not applicable
0111 (7) Pin is connected to Peripheral signal not applicable
1000 (8) Pin is connected to Peripheral signal usb0.data2
1001 (9) Pin is connected to Peripheral signal not applicable
1010 (10) Pin is connected to Peripheral signal not applicable
1011 (11) Pin is connected to Peripheral signal not applicable
1100 (12) Pin is connected to Peripheral signal not applicable
1101 (13) Pin is connected to Peripheral signal uart1.tx
1110 (14) Pin is connected to Peripheral signal nand.adq3
1111 (15) Pin is connected to Peripheral signal gpio0.io6
 RW 0xF