timersintstat
Name: Timers Interrupt Status Register
Size: 1-9 bits
Address Offset: 0xa0
Read/Write Access: Read
| Module Instance | Base Address | Register Address |
|---|---|---|
| i_timer_sp_0_timer | 0xFFC02700 | 0xFFC027A0 |
| i_timer_sp_1_timer | 0xFFC02800 | 0xFFC028A0 |
Offset: 0xA0
Access: RO
Important: The value of a reserved bit must be maintained in software. When you modify registers containing reserved bit fields, you must use a read-modify-write operation to preserve state and prevent indeterminate system behavior.
| Bit Fields | |||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
| 31 | 30 | 29 | 28 | 27 | 26 | 25 | 24 | 23 | 22 | 21 | 20 | 19 | 18 | 17 | 16 |
Reserved |
|||||||||||||||
| 15 | 14 | 13 | 12 | 11 | 10 | 9 | 8 | 7 | 6 | 5 | 4 | 3 | 2 | 1 | 0 |
Reserved |
timersintstat RO 0x0 |
||||||||||||||
timersintstat Fields
| Bit | Name | Description | Access | Reset | ||||||
|---|---|---|---|---|---|---|---|---|---|---|
| 0 | timersintstat | Contains the interrupt status of all timers in the component. If a bit of this register is 0, then the corresponding timer interrupt is not active and the corresponding interrupt could be on either the timer_intr bus or the timer_intr_n bus, depending on the interrupt polarity you have chosen. Similarly, if a bit of this register is 1, then the corresponding interrupt bit has been set in the relevant interrupt bus. In both cases, the status reported is the status after the interrupt mask has been applied. Reading from this register does not clear any active interrupts: 0 = either timer_intr or timer_intr_n is not active after masking 1 = either timer_intr or timer_intr_n is active after masking.
|
RO | 0x0 |